Abstract:Regenerator is one of heat exchangers (heater, regenerator and cooler) in a Stirling engine, whose flow characteristics are very important for developing Stirling engine design methodology. A combined experimental and simulation study is carried out to investigate characteristics of regenerator in an oscillating flow, using steady flow as reference. It is found that the oscillating flow can share the same correlation equations of steady flow for friction factor within the measured kinetic Reynolds number range (2.59×10−2–2.04×10−1 for 100mesh, 6.60×10−3–5.22×10−2 for 200mesh, 2.74×10−3–2.16×10−2 for 300mesh and 1.43×10−3–1.13×10−2 for 400mesh) and dimensionless fluid displacement, and the maximum deviation between the experimental data and simulation results is found less than 9.6%. It is also found that the effect of gas compression can’t be ignored for the steady and oscillating flows through a regenerator with the increase of mass flow, and the pressure drop per unit length decreases as the length of regenerator increases. The velocities at both ends of regenerator are also affected by the compression of gas, and it is found that theoretical velocity based on piston velocity can be used if the dimensionless pressure drop of the whole system is less than 4.22×10−2 in this experiment. After all, it should be noted that oscillating flow has its own characteristics, and obvious flow perturbations are found at downstream of regenerator, which are exactly detected by a hot wire anemometer. The effect of mesh size, frequency and mean pressure on the perturbation is investigated, and a correlation equation for the duration of perturbation is proposed based on dimensionless pressure drop of regenerator.

2-D Models of Magnet and Active Magnetocaloric Regenerator.

Frequency Correlated Heat Transfer Characteristics of Parallel Plate Active Magnetocaloric Regenerator

Numerical Study on the Multi-Layered Magnetocaloric Regenerators

Numerical Investigation of a Packed-Bed Active Magnetic Regenerator

Numerical analysis of an active magnetic regenerator with parallel wire geometry based on a 1D AMR model

Numerical Investigation of Room Temperature Magnetic Refrigerator Using Microchannel Regenerators

Numerical Investigations on Internal Temperature Distribution and Refrigeration Performance of Reciprocating Active Magnetic Regenerator of Room Temperature Magnetic Refrigeration

Critical Parameters in Design of Active Magnetocaloric Regenerators for Magnetic Refrigeration Applications

Experimental Study on Cooling Performance of Active Magnetic Regenerators with Different Structures

A Comprehensive Two-Dimensional Numerical Study on Unsteady Conjugate Heat Transfer in Magnetic Refrigerator with Gd Plates

The influence of the magnetic field on the performance of an active magnetic regenerator (AMR)

Numerical Modeling of an Active Elastocaloric Regenerator Refrigerator with Phase Transformation Kinetics and the Matching Principle for Materials Selection

Experimental Investigation on the Performance of a Parallel Plate-Based Active Magnetic Regenerator

Modeling of Heat Transfer and Oscillating Flow in the Regenerator of A Pulse Tube Cryocooler Operating at 50 Hz

Characteristics of Steady and Oscillating Flows Through Regenerator

Thermodynamic modeling, material selection, and new dimensioning of a multilayer regenerator for a magnetic refrigeration system

A full solid-state conceptual magnetocaloric refrigerator based on hybrid regeneration

COORDINATION ANALYSIS OF MAGNETOTHERMAL CONVECTION IN HORIZONTAL TUBE

Oscillatory and Periodical Behavior of Heat Transfer and Magnetic Flux along Magnetic-Driven Cylinder with Viscous Dissipation and Joule Heating Effects

The Performance Optimization of an Active Magnetocaloric Regenerator Refrigerator for Near Room Temperature Application.

Impact of different numerical approaches on the magnetocaloric effect modeling