Abstract:How to prevent the cracking of tunnel lining concrete under a high-temperature and low-humidity environment has gradually become a challenge faced by the engineering community. Actually, the concrete structure will be restrained, which easily leads to cracking. Aiming at this problem, a self-restraint device of concrete specimens was designed in this paper, which aims to more realistically simulate the restrained state of concrete structures during construction. SEM, EDS and XRD detection methods were used to study the macroscopic and microscopic properties of an early-age restrained concrete specimen under a high-temperature and low-humidity environment, and the results were compared with those of a non-restrained concrete specimen. The results show that the change in the internal relative humidity of the concrete was an extremely slow process, and the response rate of the internal humidity of the concrete was much slower than that of the temperature. A cubic curve model was used to fit the measured concrete damage degree with the loading age, and the fitting effect was good. Under the environment of high temperature and low humidity, the loading age from the 0.6th day to the 1st day was the period of a relatively large fluctuation in the concrete temperature and humidity, and the restraint would aggravate the damage of the concrete. The damage degree increased with the increase in the loading age, the microcracks gradually increased and, finally, macrocracks were formed. The restraint effect was to intensify the formation of microcracks, affect the hydration of the cement at the micro level and, finally, increase the risk of concrete cracking perpendicular to the restrained direction at the macro level. The research results may provide guidance for research on the cracking mechanism of tunnel lining concrete constructed under a high-temperature and low-humidity environment.

RESEARCH ON INDIRECT STRESS AND CRACK CONTROL OF CONCRETE STRUCTURES

Investigation and Control of Cracks in Wet Joint of Concrete Box Girders

Finite element analysis of temperature effect and crack-control measures for ultra-long concrete structures

Influence of Steel Reinforcement on Shrinkge Stress of Concrete

Effects of Reinforcement Bar on Shrinkage Stress of Concrete

State-of-art of corrosion-induced cracking of reinforced concrete structures

Early Age Properties and Cracking Control of Concrete

Numerical Analysis of Drying Shrinkage in Long Reinforced Concrete Structure

Research on Crack-Resisting Construction Design Method of Concrete Small Cavity Block Building Based on Temperature Effect

Analytical Prediction and Experimental Research on Shrinkage Cracking of Restrained Early-Age Concrete

Effect of Reinforcement on Early-Age Concrete Temperature Stress: Preliminary Experimental Investigation and Analytical Simulation

Control Joints in Cast In Situ Concrete Slabs and Its Application

Mechanical properties and numerical simulation of crack interface in reinforced concrete

Influence of Flexural Loading on Chloride Ingress in Concrete Subjected to Cyclic Drying-Wetting Condition

Cracking Behaviour of Cast in Situ Reinforced Concrete Slabs with Control Joints

EXPERIMENTAL AND NUMERICAL ANALYSIS OF EARLY-AGE STRESS IN CONCRETE DIAPHRAGM WALL OF UNDERGROUND STRUCTURES

Research on Cracking Mechanism of Early-Age Restrained Concrete under High-Temperature and Low-Humidity Environment

Restrained Cracking Failure Behavior of Concrete Due to Temperature and Shrinkage

Experimental and Theoretical Investigations on Crack Spacing and Stiffness of Textile-Reinforced Concrete–strengthened Reinforced Concrete Beams

Experimental Study on Early-Age Crack of Mass Concrete under the Controlled Temperature History

Analyzing of Cracking Risk of Early-age Concrete Structure