Oxidative Coupling of Methane over Li/TiO2 in Solid-State Electrolyte Membrane Reactor

李俊,石勇,王宇红,卢冠忠,赵玲
DOI: https://doi.org/10.3321/j.issn:1003-9015.2008.06.012
2008-01-01
Abstract:Li/TiO2 film was prepared by impregnation method with Li2CO3 as Li source,and then the XRD and TG-DTA were adopted for the characterization of the prepared film.It was found that,during calcinations,chemical reaction between Li2CO3 and TiO2 takes place and forms a new compound of Li1.33Ti1.66O4.The oxidative coupling process of methane on Li/TiO2 film supported on yttria-stabilized zirconia was studied by using two different oxygen supply methods,the electrochemical oxygen supply and premixed oxygen supply,respectively.The effects of methane partial pressure,reaction temperature and time etc.on the methane conversion rate,products formation rate and selectivity of forming C2 hydrocarbons were investigated;the reaction mechanism was also analyzed.The results indicate that the higher methane partial pressure and higher reaction temperature benefit the methane conversion and the selectivity of forming C2 hydrocarbons;higher O2 pressure of premixed oxygen supply or higher the electric current density used for electrochemical O2 supply is advantageous to methane conversion but disadvantageous to the goal products selectivity which is caused by the much faster formation rate of carbon dioxide.It was also found that when using the electrochemical O2 supply method,the concentration of O2 on Li/TiO2 film is higher than the O2 concentration in the gas phase,therefore under the condition of having the same methane partial pressure,reaction temperature and the O2 flux,using electrochemical O2 supply method can get higher methane conversion rate and forming C2 hydrocarbons selectivity than those of using premixed O2 supply method.
What problem does this paper attempt to address?