Abstract:Abstract The transfer of gas-liquid reactions from conventional batch processes into continuous operation using milli and micro reactors is claimed as an important step towards process intensification. Importantly, this transfer step should be realized in an early phase of process development, already, in order to minimize research efforts towards the undesired operation strategy. The main challenge of this approach, therefore, arises from lack of knowledge in the early stage of process development and the resulting system with high degrees of freedom. This contribution presents an approach to tackle this challenge by means of mathematical modelling and simulation for the aerobic oxidation of 9,10-dihydroanthracene (DHA) catalyzed by polyoxometalates (POMs) being used as example for gas-liquid reactions. The reaction was chosen as it provides sufficient complexity, since it consists of three consecutive oxidation steps of DHA and a parallel catalytic redox-cycle according to a Mars-van-Krevelen mechanism. It also provides the challenge of unknown reaction kinetics, which have been estimated in this contribution. The dimensionless balance equations for reactor modeling are derived and parametrized based on early stage experimental results obtained in batch operation mode. The discrimination between batch and continuous operation was performed by means of characteristic dimensionless numbers using the identical mathematical model for comparability reasons. The model was used to perform sensitivity studies with emphasis on the interplay between mass transfer characteristics and reaction kinetics for both the batch and continuous operation mode. The simulation results show that the performance of both operation modes mainly depend on the oxidation state of the POM catalyst, which is caused by the differences in oxygen availability. Therefore, results obtained in batch operation mode are prone to be masked by mass transfer issues, which affects catalyst and reactor development at the same time and may thus cause maldevelopments. With respect to process development it can thus be concluded that the transfer from batch to continuous operation together with mathematical modeling is important in an early phase, already, in order to detect limitations misleading the development. Finally, even simple models with roughly estimated parameters from preliminary experiments are shown to be sufficient in the early phase and can systematically be improved, in the subsequent phases. Graphical abstract

Periodically operated trickle-bed reactor for EAQs hydrogenation: Experiments and modeling

Cstr Model for P-Xylene Oxidation Reactor

Kinetic Model and Simulation Analysis for Toluene Disproportionation and C9-Aromatics Transalkylation

Conversion of non-alpha-tocopherols to alpha-tocopherol in a fixed bed reactor

Unsteady-state Operation of Trickle-Bed Reactor for Dicyclopentadiene Hydrogenation

Modeling of a Pilot-Scale Trickle Bed Reactor for the Catalytic Oxidation of Phenol

Operando Nuclear Magnetic Resonance (NMR) studies of a Trickle-bed Reactor using D-T2 Correlations

Process Intensification of Quasi-Homogeneous Catalytic Hydrogenation in a Rotating Packed Bed Reactor

Process Optimization for Microcystin-Lr Degradation by Response Surface Methodology and Mechanism Analysis in Gas-Liquid Hybrid Discharge System

Modeling and Simulation of a Three Phase Fixed Bed Catalytic Reactor for the Hydrogenation of 2-ethyl-hexenal

Performance analysis of crude terephthalic acid hydropurification in an industrial trickle-bed reactor experiencing catalyst deactivation

Modeling and Design of a Multi-Tubular Packed-Bed Reactor for Methanol Steam Reforming over a Cu/ZnO/Al2O3 Catalyst

Dynamic Modeling Strategy To Assess Impacts of Hydrodynamic Parameters on Industrial Hydropurification Process by Considering Catalyst Deactivation

Optimization of the Countercurrent Continuous Reforming Process Based on Equation-Oriented Modeling and the SQP Algorithm

Effect of Periodic Variation of the Inlet Concentration on the Performance of Reverse Flow Reactors

Performance analysis, statistical modeling, and multiple response optimization of a novel fixed-bed quartz reactor packed with Ba-Pt@γ-AL2O3 using response surface methodology

Challenges in transfer of gas-liquid reactions from batch to continuous operation: dimensional analysis and simulations for aerobic oxidation

Transient modeling of toluene waste gas biotreatment in a gas–liquid airlift loop reactor

Cfd Modelling of Transient Performance of Toluene Emissions Biodegradation in Bubble Column

Analysis of Hydrodynamic Parameters Effect on the Hydropurification Reactor Operation through Numerical Simulation

A new design of catalytic tube reactor for hydrogen production from ethanol steam reforming