Abstract:The roughness of the road surface is one of the most important indicators of the pavement quality as-sessment.Based on the pavement quality assessment in the analysis of road roughness,this article designs the road roughness acquisition system based on the acceleration sensor.For the hardware part of the system,the sig-nal collecting module is developed with C805 1 F005 micro-controller that can measure vehicle vertical accelera-tion analog signal which is from negative one point two volts to one point two volts,and then it is adjusted to the appropriate signal range which is from zero to three point three volts of the input signal range of A/D conversion module.A/D converting digital signal is sent to the bluetooth by the UART serial port of the micro-computer, and then transmitted to the PC;the software part of the system adopts a method based on vehicle vertical acceler-ation time series auto-regressive (AR)modeling of international road roughness index (IRI)measurement.In other words,it uses the Kalman algorithm to filter the initial data,and then calculates power spectrum density (PSD)by AR model.After getting the road roughness coefficient,the road IRI can be calculated by the formu-la.We give the concrete implementation plan,analyze rationality of the scheme,and used the collection system developed to carry out the real vehicle road test.As is well known,concrete pavement and asphalt pavement are the most common type of urban roads,so this article finally decides to collect two roads of Zhenjiang district which are asphalt pavement and cement concrete pavement.After test,we found that the IRI of Xuefu road was 2.593,and the IRI of Qingfen road was 1.954,and both of them were A level road.At the same time,we used high accurate laser surface flatness cytometry to do a comparative test.The experimental results showed that the scheme proposed had small errors and was consistent with realistic conditions.At the same time,it also proved that the design of road surface acquisition hardware device was reasonable and effective,and this system could be applied to engineering road detection and classification and some other related areas.

Study on an Approach to Measure Road Roughness Spectrum of Tracked Vehicle Measurement Road

A Study on the System of Road Roughness Simulation and its Visualization

Design of road roughness collecting system based on acceleration sensor

Road Roughness Research of Tracked Vehicle Compliance Simulation Experiment

Videogrammetry in Highway Roughness Measurement

Analysis on Measuring Technology of Road-roughness and Its Development

Research on Road Spectrum Simulation System Using a Laser Displacement Sensor

Power Spectrum Computation of Road Roughness Based on Matlab

Estimation of Road Roughness Based on Both the Sprung and Unsprung Response of a Moving Vehicle over Ordinary Roads: Modeling, Experiments and Discussions

Vehicle parameter identification and road roughness estimation using vehicle responses measured in field tests

The research of road profile estimation based on acceleration measurement

A high-precision two-parameter road roughness grading and identification methodology across multiple frequency intervals

A New Method for Detecting the Quality of Special Road in Automobile Proving Ground

Feasibility Research on Road Response Spectrum Testing of Tracked Vehicle

Measurement of international roughness index based on vehicle vertical dynamic load modeling method

Research on the Method of Whole Vehicle Load Spectrum Compilation Based on Road Surface irregularity

Low-Cost Portable Road Smoothness Testing Method Based on Pseudo-Vibration Velocity Range

Analysis of road roughness reconstruction of lunar rover experiment road

Study of On-vehicle Highway Smoothness Determination Instrument Based on ARM7

Assessing and Mapping of Road Surface Roughness based on GPS and Accelerometer Sensors on Bicycle-Mounted Smartphones

Simulation Research on Time Domain Model of Road Roughness with Time-Space Correlation