Abstract:θ-Al13Fe4 is one of the common Fe-containing intermetallic compounds (FIMCs) that forms during solidification in Al alloys. Silicon (Si) as impurity or solute in Al alloys is easily doped into θ-Al13Fe4, which not only causes compositional variation but also modifies the lattice parameters, and in some circumstances, modifies or changes the crystal structure of θ-Al13Fe4. In this study, multiple Al-Fe and Al-Fe-Si alloys which solidified θ-Al13Fe4 as equilibrium or non-equilibrium phase in primary or eutectic structures were designed and investigated. Different types of phase transformation among θ-Al13Fe4 and the other FIMCs such as α’-Al8Fe2Si, α-Al15(Fe,Mn)3Si2 and β-Al5FeSi were investigated with scanning electron microscopy (SEM), transmission electron microscopy (TEM) and single crystal X-ray analysis. The composition and lattice parameters of FIMCs observed in this study were measured by TEM and X-ray analysis. The orientation relationships between θ-Al13Fe4 and the other types of FIMCs (α’-Al8Fe2Si, α-Al15(Fe,Mn)3Si2 and β-Al5FeSi) were determined with TEM analysis. The phase selection and solidification sequence were investigated by comparing the phase diagram calculation and the casting experiments. The configuration entropy of FIMCs was calculated to build up structural models. Finally, the influence of incorporation of Si into θ-Al13Fe4 on the phase transformation between θ-Al13Fe4 and the other types of FIMCs were discussed from crystallographic and thermal stability perspectives.

Effect of Solubility of Aluminum Sources and Iron Loadings on the Structure and Morphology of FeAIPO-5 Molecular Sieves

Synthesis and crystal morphology control of AlPO4-5 molecular sieves by microwave irradiation

The State of Iron Sites in the Calcined FeAlPO4-5 and Its Tuning to the Property of Microporous AlPO4-5 Molecular Sieve

Studies on preparing molecular sieves AIPO4-5 and AIPO4-11 by the vapour phase method

Synthesis Of Fe-Doping Aluminum Titanate Powders

Cooperative structure-directing effect in the synthesis of aluminophosphate molecular sieves in ionic liquids.

Synthesis of the Molecular-Sieve Alpo4-5 with an Unequal Molar Ratio of Al2o3 to P2o5

Synthesis of Fe, Co, and Mn substituted AlPO-5 molecular sieves and their catalytic activities in the selective oxidation of cyclohexane

Effect of the alumina and silica source mixing procedure on the microstructural evolution of alumina-mullite composite fibers prepared by sol–gel method

Synthesis and Catalytic Properties of Large Single Crystal FeAPO-5 Molecular Sieves

Ionothermal Synthesis of Hierarchical Structured CuAPO-5 Molecular Sieve

Effect of Adding Cr2O3/Fe2O3 on Aluminum Titanate Properties

Study on the structure activity relationship of the crystal MOF-5 synthesis, thermal stability and N2 adsorption property

Insights of the Crystallization Process of Molecular Sieve AlPO4-5 Prepared by Solvent-Free Synthesis.

"Solvent-free" synthesis of thermally stable and hierarchically porous aluminophosphates (SF-APOs) and heteroatom-substituted aluminophosphates (SF-MAPOs)

Study on the effect of inorganic aluminum sources on ZSM-5 zeolite synthesis by solvent-free method from rice husk ash

Effects of Si solution in θ-Al13Fe4 on phase transformation between Fe-containing intermetallic compounds in Al alloys

Effects of SiO2 Addition on Phase Transition and Microstructure Evolution of Alumina Fibers Prepared Using the Sol-Gel Method

Mesoporous Α-Fe2o3 Nanospheres: Structural Evolution and Investigation of Magnetic Properties.

Effects of aluminum on micro-sized pore structure of porous MoAlB ceramics fabricated via reactive synthesis

Enhancing Stability of SAPO-37 Molecular Sieve through Aluminum Phosphate Utilization: Synthesis, Stability Mechanism, and Catalytic Performance