Abstract:The prevalence of concrete-filled steel tubular (CFST) catenary arches, renowned for the optimal load-bearing efficiency, has shown a marked increase over the past decades. To date, extensive research has been conducted into the nonlinear buckling behaviors and elastic-plastic strength of circular and parabolic CFST arches, grounded on the assumption that the curvature of the arch axis remains a specific constant. However, for CFST catenary arches, this assumption is not appropriate, given the substantial variation in curvature along the arch rib, and the influence of the arch axis is not adequately addressed in the existing design codes. Therefore, in this paper, a more precise strain expression is employed to conduct the nonlinear buckling analysis on CFST catenary arches. The analytic solutions for both symmetric snap-through buckling and anti-symmetric bifurcation buckling loads are obtained. In addition, a validated finite element (FE) model is adopted to investigate the influence of key parameters, including the slenderness ratio , the arch-axis coefficient, the rise-to-span ratio, and the steel ratio, on the in-plane stability bearing capacity of CFST catenary arches subjected to axial compression. Moreover, the obtained numerical results are utilized for comparison with the prediction results calculated by the existing design codes for CFST or steel arches. The comparison results indicate that the existing design codes have tended to overestimate the in-plane strength of CFST catenary arches, mainly due to the ignorance of the influence of pre-buckling deformation. Thus, based on the nonlinear buckling analysis results, a revised lower-bound design formula for predicting the in-plane stability bearing capacity of CFST catenary arches under axial compression is proposed, considering the influence of the rise-to-span ratio and the steel ratio.

In-plane Elastic Buckling Coefficients of Compression Steel Arch with Uniform Section

IN-PLANE ELASTIC BUCKLING OF STEEL CIRCULAR ARCHES WITH HORIZONTAL SPRING SUPPORT

Elastic Lateral–torsional Buckling of Circular Arches Subjected to a Central Concentrated Load

Numerical Analysis of Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges

In-plane buckling analysis of the horsizontal spring circular arch under concentrated load at the mid-span

In-plane Nonlinear Buckling Analysis of Circular Arches Considering Shear Deformation

In-plane ultimate strenth of H-section three-hinged steel circular arches subjected to hydrostatic pressure

Elastic-plastic Stability of Shear-Deformable Circular Arches

In-Plane Nonlinear Buckling Analysis of Deep Circular Arches Incorporating Transverse Stresses

STUDY FOR IN-PLANE ULTIMATE STRENGTH OF STEEL CIRCULAR ARCHES WITH HORIZONTAL SPRING SUPPORTS

Finite-element Analysis for Nonlinear Stabilities of Concrete-filled Steel Tubular Arch Bridges

IN-PLANE NONLINEAR ANALYSIS AND BUCKLING OF SHEAR-DEFORMABLE CIRCULAR ARCHES

LOCAL BUCKLING OF I-SECTIONS IN COMPRESSION AND BENDING

Elastic and Inelastic Stability of a Steel Arch Subjected to a Crown Point Load under an Elevated Fire Environment

In-Plane Elastic Buckling of Arch

In-plane Buckling and Design of Two-Hinged Steel Tube Circular Truss-Arches under Pure Compression

In-plane stability design curves of two-hinged steel circular arches in uniform compression

An Experimental Study on Out-of-plane Inelastic Buckling Strength of Fixed Steel Arches

OUT-OF-PLANE STABILITY DESIGN OF PIN-ENDED CIRCULAR STEEL ARCH UNDER PURE COMPRESSION

In-plane nonlinear buckling analysis and design method of concrete-filled steel tubular catenary arches

In-Plane Failure and Strength of Pin-Ended Circular Steel Arches Considering Coupled Local and Global Buckling