Influence of Oxygen Partial Pressure on Electrical and Optical Properties of Zn0.93Mn0.07O Thin Films

Xue-Yong Li,Hong-Jian Li,Ming Yuan,Zhi-Jun Wang,Zi-You Zhou,Ren-Bo Xu
DOI: https://doi.org/10.1016/j.jallcom.2010.11.191
IF: 6.2
2010-01-01
Journal of Alloys and Compounds
Abstract:The Zn1-xMnxO (x = 0.07) thin films were grown on glass substrates by direct current reactive magnetron cosputtering. The influence of oxygen partial pressure on the structural, electrical and optical properties of the films has been studied. X-ray-diffraction measurement revealed that all the films were single phase and had wurtzite structure with c-axis orientation. The experimental results indicated that there was an optimum oxygen partial pressure where the film shows relative stronger texture, better nano-crystallite and lower surface roughness. As the oxygen partial pressure increases, the carrier concentration systematically decreases and photoluminescence peaks related to zinc interstitials gradually diminish. The minimal resistivity of 70.48 Omega cm with the highest Hall mobility of 1.36 cm(2) V-1 s(-1) and the carrier density of 6.52 x 10(16) cm(-3) were obtained when oxygen partial pressure is 0.4. All films exhibit a transmittance higher than 80% in the visible region, while the deposited films showed a lower transmittance when oxygen partial pressure is 0.4. With the increasing of oxygen partial pressure, the peak of near-band-edge emission has firstly a blueshift and then redshift, which shows a similar trend to the band gap in the optical transmittance measurement. (C) 2010 Elsevier B.V. All rights reserved.
What problem does this paper attempt to address?