Abstract:In a circulating fluidized bed (CFB) boiler, one of the basic functions of the bed materials is to transport heat between different parts of the boiler to clecrease heat gradients and, thereby, smoothen the operation. A novel concept, oxygen Carrier-aided combustion (OCAC), replaces some or all of the bed materials with an oxygen carrier, which is a metal oxide that, through chemical redox reaction, not only transports heat but also transports oxygen between oxygen-lean and oxygen-rich areas of the boiler. The oxygen carrier also acts as internal oxygen storage, which increases the total amount of available oxygen in the boiler. The concept of OCAC was demonstrated by Thunman et al. at Chalmers University of Technology, where the bed material (sand) in a 12 MW boiler was replaced with iron titanium mineral (ilmenite). In this work, a small fluidized bed reactor is used to mimic the condition in OCAC with regard to fuel conversion as well as NO formation and to test other oxygen carrier, materials. Four oxygen carriers were tested, two ores (ilmenite and manganese ore), and two Oxide scales (denoted as AQS and LDst), which were byproducts from the steel production of the Swedish company SSAB. Sand was also used as a reference. Wood char was used as the fuel, and concentrations of CO2, CO, CH4, O-2, and NO in the exhaust gases were monitored. The effect of oxygen carriers on combustion efficiency and NO emission was investigated at different air/fuel ratios. The results Show that, utilization of an oxygen carrier reduces the level of CO emission, thereby increasing the efficiency of combustion. It is also Shown that the increase In combustion efficiency can be largely attributed to the reactivity of the oxygen carriers with CO. With OCAC, it was possible to reduce the level of excess air and, thereby, lower the level of NO emissions while maintaining the same level of CO emission.

Continuous O 2 -CO 2 Production Using a Co-based Oxygen Carrier in Two Parallel Fixed-Bed Reactors

Experimental Study Of O-2-Co2 Production For The Oxyfuel Combustion Using A Co-Based Oxygen Carrier

Tuning the Support Properties Toward Higher CO2 Conversion During a Chemical Looping Scheme.

Simultaneous CO 2 Capture and H 2 Generation Using Fe 2 O 3 /al 2 O 3 and Fe 2 O 3 /cuo/al 2 O 3 As Oxygen Carriers in Single Packed Bed Reactor Via Chemical Looping Process

Multifunctional Ni-based oxygen carrier for H2 production by sorption enhanced chemical looping reforming of ethanol

Mn-Fe-Al-O Mixed Spinel Oxides As Oxygen Carrier for Chemical Looping Hydrogen Production with CO2 Capture

Long-term coal chemical looping gasification using a bimetallic oxygen carrier of natural hematite and copper ore

Oxygen Separation Through U‐shaped Hollow Fiber Membrane Using Pure CO2 As Sweep Gas

Chemical-Looping Combustion with Iron-Based Oxygen Carries

Evaluation of Fe-Ni Composite Oxygen Carrier in Coal Chemical Looping Gasification

Thermochemical CO2 Splitting Enhanced by in Situ Oxygen Separation Through CeO2 and CaTiO3 Membranes

A High-Performance Oxygen Carrier with High Oxygen Transport Capacity and Redox Stability for Chemical Looping Combustion

Enhanced performance of the CeO2MgO oxygen carrier by NiO for chemical looping CO2 splitting

Performance of Ni-Based, Fe-Based and Co-Based Oxygen Carriers in Chemical-Looping Hydrogen Generation

Characteristics of SrCo1-xFexO3-δPerovskite Powders with Improved O2/CO2Production Performance for Oxyfuel Combustion

Oxygen-Carrier-Aided Combustion in a Bench-Scale Fluidized Bed

One ASU Alternative: O2-CO2 Production for Oxyfuel Combustion Using Chemical Looping Method

Thermochemical CO 2 Splitting Enhanced by In Situ Oxygen Separation through CeO 2 and CaTiO 3 Membranes

Continuous CO2 Cycloaddition to Cyclic Carbonate in a Membrane Dispersion Enhanced Fixed-Bed Reactor

Continuous CO 2 Capture in a Circulating Fluidized Bed Using Supported Amine Sorbents

Oxy-Fuel Combustion for Co2 Capture Using A Co2-Tolerant Oxygen Transporting Membrane