Propylene polymerization catalyzed by constrained geometry (cyclopentadienyl)phenoxytitanium catalysts

Chunsheng Lü,Yuetao Zhang,Ying Mu
DOI: https://doi.org/10.1016/j.molcata.2006.05.025
2006-01-01
Abstract:Propylene polymerization was performed using three constrained geometry catalysts: 2-(tetramethylcyclopentadienyl)-4,6-di-tert-butylphenoxytitanium dichloride (1), 2-(tetramethylcyclopentadienyl)-6-tert-butylphenoxytitanium dichloride (2), and 2-(tetramethylcyclopentadienyl)-6-phenylphenoxytitanium dichloride (3) with Al(iBu)3/[Ph3C]+[B(PhF5)]4− as co-catalyst. The substituent effect of the ligand and the effect of the Al/Ti molar ratio on the catalytic properties were investigated. The catalytic activity decreases in the order of 1>2>3. The 13C NMR results show that the polymers are basically atactic polypropylene with some 2,1-insertion and 1,3-enchainment units in the polymer chain, and the end groups are mainly vinylidene (CH2CMe–) and vinyl (CH2CH–) together with a small amount of propenyl (CH3CHCH–). A possible chain propagation and termination mechanism of the propylene polymerization was discussed.
What problem does this paper attempt to address?