Abstract:This work attempts to prepare ethylene-a-olefin copolymer with relatively narrow composition distribution by modification of TiCl4/MgCl2 type supported Ziegler-Natta catalyst. A TiCl4/ID/MgCl2 type catalyst, where ID is a diester, was treated at room temperature with 2,6-'Pr2C6H3-OH at phenol: Ti molar ratio of 1:1 and the modified catalyst was analyzed for contents of titanium and aryloxy group. It was found that about one third of the titanium atoms in the modified catalyst (M-cat) was connected with an aryloxy group, but its Ti content was decreased to 1.44 wt% from 2.36 wt% of the original catalyst (O-cat). Ethylene-1-hexene copolymerization was conducted in n-heptane with M-cat or O-cat as catalyst and triisobutyl aluminium or methylaluminoxane as cocatalyst. The M-cat showed similar activity as the O-cat in catalyzing the copolymerization, but presented a weaker comonomer activation effect than the latter. The 1-hexene content of copolymer synthesized by M-cat was lower than that of the product of O-cat at the same conditions, but had a markedly narrower composition distribution. Each copolymer sample was fractionated into two fractions by extraction with boiling n-heptane, and the soluble part contains much more 1-hexene units than the insoluble part. The ratio of I-hexene content in the soluble fraction to that of the insoluble fraction was higher than 18 in copolymer prepared with O-cat, but this ratio was reduced to 3.7 when M-cat was used as the catalyst. On the other hand, the soluble part of copolymer prepared with M-cat showed a more random sequence distribution than that of the O-cat. The distributions of active centers in both the M-cat and O-cat were studied by deconvolution of the polymer's molecular weight distribution curves with multiple Flory most-probable distribution function. Both catalysts showed a broad molecular weight distribution that can be ascribed to 5 similar to 6 types of active centers, but the introduction of aryloxy group in the catalyst caused marked changes in the active center distribution. Possible mechanism of the catalyst modification was proposed.

Ethylene/α‐olefin Copolymerization Using Diphenylcyclopentadienyl‐phenoxytitanium Dichloride/al(ibu)3/[ph3c][b(c6f5)4] Catalyst Systems

Ethylene polymerization by diphenyl ether bridged dinuclear titanocenes/MAO

Ethylene Polymerization with Novel Phenoxy-Imine Catalysts Bearing 4-Vinylphenyl Group

Ethylene/1-Octadecene Copolymerization Using [Eta(5):Eta(1)-C5me4-4-R-1-6-R-C6h2o]Ticl2 Catalysts

Effect of Catalysts Supporting on Tandem Polymerization of Ethylene Stock in Synthesis of Ethylene-1-Hexene Copolymer

REMARKABLY ACTIVE NON-METALLOCENE ETHYLENE POLYMERIZATION CATALYSTS

Ethylene polymerization with metallocene/late transition metal combined catalysts

Synthesis of Ethylene‐1‐hexene Copolymers from Ethylene Stock by Tandem Action of Bis(2‐dodecylsulfanyl‐ethyl) Amine‐crcl3 and Et(Ind)2ZrCl2

Synthesis of Ultrahigh-Molecular-weight Ethylene-1-hexene Copolymers with High Hexene Content Via Living Polymerization with Fluorinated Bis(phenoxy-Imine) Titanium(iv).

Ethylene/α‐olefin Copolymerization with Bis(β‐enaminoketonato) Titanium Complexes Activated with Modified Methylaluminoxane

Aluminum bis(iminophosphorano)methanide and methandiide complexes—transition metal-free ethylene polymerization cationic catalyst precursors

Copolymerization of Ethylene and Cyclopentene with Bis(β‐enaminoketonato) Titanium Complexes

Copolymerization of Ethylene with Dicyclopentadiene Using a Constrained Geometry Cyclopentadienyl-phenoxytitanium Catalyst

Binuclear Heteroligated Titanium Catalyst Based on Phenoxyimine Ligands: Synthesis, Characterization, and Ethylene (Co)polymerization

Constrained Geometry Tetramethylcyclopentadienyl-phenoxytitanium Dichlorides: Template Synthesis, Structures, and Catalytic Properties for Ethylene Polymerization

Ethylene–propylene Copolymerization with Bis(β‐enaminoketonato) Titanium Complexes Activated with Modified Methylaluminoxane

Ethylene/1-hexene Copolymerization with TiCl4/MgCl2/AlCl3 Catalyst in the Presence of Hydrogen

Copolymerization of Ethylene and 1-Hexene with TiCl 4 /mgcl 2 Catalysts Modified by 2,6-Diisopropylphenol

Synthesis, Structures, and Catalytic Properties of Constrained Geometry Cyclopentadienyl-Phenoxytitanium Dichlorides

The Investigation of Novel Non‐metallocene Catalysts with Phenoxy‐imine Ligands for Ethylene (Co‐)polymerization

Ethylene-1-Hexene Copolymerization with A 2,6-Diisopropylphenol Modified Supported Ziegler-Natta Catalyst