Abstract:Nowadays, the number of emergency situations related to fires is quite high. The high percentage of human deaths is mainly due to poisoning by gaseous toxic substances including carbon monoxide. The most problematic issue is the development or application of existing catalysts in means of individual protection of human respiratory organs – respirators, gas masks, self-rescuers. The compositions based on thermally modified tripoli obtained by the method of impregnation of the carrier by moisture content with compounds of copper(II), palladium(II) and potassium bromide were investigated. According to X-ray phase analysis, it was established that thermally modified tripoli is a polyphase crystalline mineral containing the following main phases: a-quartz, a-tridymite, b-cristobalite, a-cristobalite. The influence of the initial concentration of CO, which does not exceed 15 MPC, on the kinetic and stoichiometric parameters of the reaction varied in the range from 100 to 300 mg/m3. It was noted that the reaction rate in the stationary mode (Wst) is directly proportional to the increase in the initial concentration of carbon monoxide in the gas phase. The values of the constant kI and the degree of CO conversion (ηst) do not depend on CinCO, which also confirms the first order of CO concentration. Particular attention is paid to the aspects of ensuring protection against carbon monoxide when its concentration exceeds 15 MPC. Usually, special equipment, such as filtering self-rescuers, is used to clean the air from carbon monoxide at concentrations from 1000 to 6500 mg/m3. The catalyst developed by us is intended for use in lightweight personal respiratory protective equipment (RPE) at concentrations not exceeding 15 MPC. Therefore, there was an interest in researching the possibilities of using this catalyst in the self-saving filter system. The concentration of carbon monoxide in the gas-air mixture was varied from 400 to 2500 mg/m3 in the presence of the К2PdCl4-Cu(NO3)2-КBr/300-Tr(K) system. It was established that Wst increases in direct proportion with an increase in the gas-air mixture up to 1250 mg/m3, which indicates the first order of the reaction according to carbon monoxide. It was found that at CinCO = 1000 mg/m3 only under the condition τ ́ = 1.13 s (mk = 10 g) the К2PdCl4-Cu(NO3)2-KBr/Tr catalyst provides air purification below the breakthrough CO concentration (CfCO = 200 mg/m3). Experiments on the influence of SO2 on the activity of carbon monoxide oxidation catalysts have shown that they lose their activity, so in air purification systems from CO, it is necessary to provide for the stage of capturing sulfur dioxide.

On Emergency Oxygen-Generation by Using Chlorate Candle for Passenger Cars

Study on Optimization of Oxygen Candle Formula for Refuge Chamber

Construction of Electrochemical Avenue for Evaluating Oxygen-Carrying Performance of a Microsphere-Based Oxygen Carrier with Bovine Serum Albumin Protection Layer

Theoretical Study on Oxygen Generation using Chlorate Candle with Microwave Induction

Production of Medically Useful Nitric Monoxide Using AC Arc Discharge

Study On Chemical Oxygen Source In Underground Emergency Refuge System

Development of a Low Oxygen Generation Rate Chemical Oxygen Generator for Emergency Refuge Spaces in Underground Mines

Application and Analysis of Self- provided Oxygen Supply Methods in Mine Refuge Chamber

Novel oxygen-enrichment method using annular air curtain for single-head roadway of plateau mine

A review on chemical oxygen supply technology within confined spaces: Challenges, strategies, and opportunities toward chemical oxygen generators (COGs)

Experimental Study on Oxygen Supply Performance Influence Factors of Potassium Superoxide Oxygen Board Used in Confined Space

Oxygen storage module with physisorption technology for closed-circuit respirators

Revitalization of Air Using a Potassium Superoxide Plate in Hypoxic Space: Performance and Kinetic Model under Natural Convection Conditions

Study on oxygen supply system of mine refuge haven

Experimental Study on Vehicle Pressure Swing Adsorption Oxygen Production Process Based on Response Surface Methodology

Emergency heater based on gas-fired catalytic combustion infrared technology: Structure, evaluation and thermal response

Study on energy saving and environmental protection generator with hydrogen–oxygen–gasoline compound fuel

Controlling Effect Of Oxygen Concentration On Fire Behavior In Low Air Pressure Cargo Compartment

CATALYST BASED ON PALLADIUM(II), COPPER(II) COMPOUNDS AND THERMALLY-MODIFIED TRIPOLI FOR THE PREPARATION OF RESPIRATORY REMEDIES FROM CARBON MONOXIDE IN EMERGENCY SITUATIONS

Simulation of Delivering Oxygen Directly to the Target Tissues by Injection

Study on Danger of Denitration Device for Gas Pipeline