Abstract:Wire-, ribbon-, and sphere-like nanostructures of polypyrrole have been synthesized by solution chemistry methods in the presence of various surfactants (anionic, cationic, or nonionic surfactant) with various oxidizing agents [ammonium persulfate (APS) or ferric chloride (FeCl3), respectively]. The surfactants and oxidizing agents used in this study have played a key role in tailoring the nanostructures of polypyrrole during the polymerization. It is inferred that the lamellar structures of a mesophase are formed by self-assembly between the cations of a long chain cationic surfactant [cetyltrimethylammonium bromide (CTAB) or dodeyltrimethylammonium bromide (DTAB)] and anions of oxidizing agent APS. These layered mesostructures are presumed to act as templates for the formation of wire- and ribbon-like polypyrrole nanostructures. In contrast, if a short chain cationic surfactant octyltrimethylammonium bromide (OTAB) or nonionic surfactant poly(ethylene glycol) mono-p-nonylphenyl ether (O pi-10) is used, sphere-like polypyrrole nanostructures are obtained, whichever of the oxidizing agents mentioned above is used. In this case, micelles resulting, from self-assembly among surfactant molecules are envisaged to serve as the templates while the polymerization happens. It is also noted that, if anionic surfactant sodium dodeyl surfate (SDS) is used, no characteristic nanostructures of polypyrrole were observed. This may be attributed to the doping effect of anionic surfactants into the resulting polypyrrole chains, and as a result, micelles self-assembled among surfactant molecules are broken down during the polymerization. The effects of monomer concentration, surfactant concentration, and surfactant chain length on the morphologies of the resulting polypyrrole have been investigated in detail. The molecular structures, composition, and electrical properties of the nanostructured polypyrrole have also been investigated in this study.

Electrosynthesis of small polypyrrole microcontainers

Electrochemical Growth of Polypyrrole Microcontainers

Direct Electrochemical Generation of Conducting Polymer Microcontainers on Silicon Substrate

Preparation of polypyrrole microstructures by direct electrochemical oxidation of pyrrole in an aqueous solution of camphorsulfonic acid

Novel Polypyrrole Microstructures Generated By Direct Electrochemical Oxidation Of Pyrrole On P-Type Silicon Substrate

Linear arrangements of polypyrrole microcontainers.

Hollow Microstructures of Polypyrrole Doped by Poly(styrene Sulfonic Acid)

Polymerization of Pyrrole on a Polyelectrolyte Hollow-Capsule Microreactor

Fabrication Of Polypyrrole Hollow Y-Junction And Capsule Using Azo-Dye Templates

Electrochemical synthesis of novel polypyrrole microstructuresElectronic supplementary information (ESI) available: Fig. S1: transmittance IR and Raman spectrum of a PPy film generated at 1.2 V. See http://www.rsc.org/suppdata/cc/b2/b209245j/

Polypyrrole Micro- and Nanowires Synthesized by Electrochemical Polymerization of Pyrrole in the Aqueous Solutions of Pyrenesulfonic Acid

Electrochemical synthesis of novel polypyrrole microstructures.

The electrochemical polymerization of polypyrrole microstructures in an aqueous solution of dodecylbenzenesulfonic acid

Electrosynthsis of Large Polypyrrole Films by Multi-Potential Steps Method

Synthesis and photoluminescence modulating of polypyrrole fluorescent nano-spheres/dots

Facile synthesis of water-dispersible conducting polymer nanospheres

Controllable synthesis of conducting polypyrrole nanostructures.

Electrochemical Fabrication of Nanoporous Polypyrrole Thin Films

One-step Synthesis of Hollow N-substituted Polypyrrole@β-Feooh Microspheres

Fabrication of Polypyrrole Wires Between Microelectrodes.

Size-controllable Polypyrrole Nanospheres Synthesized in the Presence of Phosphorylated Chitosan and Their Size Effect in Different Applications