Abstract:Epoxy resin serves as a critical insulating component in ultra-high voltage dry direct current bushings. However, the accumulation of space charges within the epoxy resin, a byproduct of charge mobility, poses a significant risk to the reliability and operational safety of bushings. Conventional space charge attenuation models, especially after voltage removal, have limited use in simulations aimed at understanding this phenomenon. This study introduces an improved model integrating the bipolar charge transport mechanism with space charge decay based on the hopping conduction mechanism and Schottky's theorem, establishes a theoretical framework for predicting the space charge behavior following voltage removal, and conducts a simulation to investigate the decay process within the internal structure of epoxy resin and measure the residual charges after voltage removal using the pulsed electro-acoustic method. The experimental data validate the accuracy of the proposed model and theoretical assumptions. The findings show that the remaining negative charges after voltage removal are not enhanced by the field enhancement; the anodic positive and cathodic positive charges are distributed in two-segment discontinuous traps, whereas the negative charges are distributed in one-segment traps. The model identifies two distinct trapping sites for anodic and cathodic positive charges, and one trapping site for negative charges. After voltage removal, when the field strength exceeded 40 kV mm(-1), positive charges exist near the upper and lower electrodes, and negative charges exist near the center of the specimen. The consistency between the simulated predictions and experimental data proves the effectiveness of the proposed model in accurately simulating the space charge decay in epoxy materials after voltage removal.

Model for electrical tree initiation in epoxy resin

Light Emission Characteristics During the Initiation of the Electric Tree in Insulating Polymers

Three-Dimensional Nanometer Features of Direct Current Electrical Trees in Low-Density Polyethylene.

Electrical tree modelling in dielectric polymers using a phase-field regularized cohesive zone model

On the Conducting and Non-Conducting Electrical Trees in XLPE Cable Insulation Specimens

The Initiation and Propagation of Electrical Trees at Different Electric Field and Temperature in XLPE

Study on conducting characteristics of electrical trees in cross-linked polyethylene cable insulation

Electrical Treeing: A Phase-Field Model

In‐situ observation of electrical tree evolution in epoxy dielectrics with internal cracks

Electrical Tree Propagation in Epoxy Resin under Bipolar Square Wave Field with Varied Frequencies

On the mechanism of tree initiation in polymers

Simulation study on electrical tree propagation under electrical and mechanical stresses

A Phase Field Model for the Propagation of Electrical Tree in Nanocomposites

Thermal-elastic free energy driven electrical tree breakdown process in epoxy resin under temperature gradient

Electrical Tree Performance in Epoxy Resin under Low-Frequency Bipolar Square- Wave Voltage

Excitonic Energy Transfer in Light Emitting Polymers

A Novel Simulation of Space Charge Decay Dynamics after Removing the Voltage in Epoxy Resin Composites

A novel simulation of space charge decay dynamics after removing voltage in epoxy resin composites

Model for Partial Discharges Associated with Treeing Breakdown: Iii. Pd Extinction and Re-Growth of Tree

Study on the Electrical Tree Propagation Evolution in Polymer Composites Via Phase Field Method

Effect of Air Gap on Electrical Tree in Epoxy Resin Under High Frequency Bipolar Square-Wave Voltage