Abstract:High-energy irradiation significantly increases the optical losses and noise coefficients of laser materials, leading to a substantial decrease in the slope efficiency or gain performance of laser output. To address this issue, we propose a strategy to enhance the radiation resistance of glasses/fibers by introducing phase interfaces. Based on the sol–gel method, through phase-separation techniques and high-temperature annealing treatments, silica-rich and phosphorus-rich phases were formed in erbium-ytterbium co-doped high-phosphorus silica glass, and nanoscale phase interfaces with specific densities, stability levels, and homogeneous distributions of doped elements were constructed between the phases. Using high-resolution transmission electron microscopy, nuclear magnetic resonance, and spectroscopic analyses, we tracked the evolution of the internal microstructure of the glasses at the atomic level. The findings confirmed that annealing effectively controlled the density of the phase interfaces formed. Under 1 kGy X-ray irradiation, glasses with effective phase interfaces exhibited significant reduction in radiation-induced attenuation (RIA) and improvement in photoluminescence intensity compared to pristine glasses. This indicated that effective phase interfaces could act as complex centers for irradiation-induced point defects, absorbing radiant energy and trapping these defects, thus mitigating high-energy radiation-induced damages. Furthermore, online irradiation tests on the Er 3+ /Yb 3+ co-doped silica fibers supported this result. Compared to pristine fiber, fibers annealed for 3 h and annealed for 20 h with different phase interfacial densities showed 45% and 73% lower RIA at 1080 nm, respectively.

Evaluation of quenching effects on silica-based erbium doped fiber micro-ring lasers

Modeling Rare-Earth Doped Microfiber Ring Lasers

Low-Threshold Microlaser in Er : Yb Phosphate Glass Coated Microsphere

Microlaser Output from Rare‐Earth Ion‐Doped Nanocrystal‐in‐Glass Microcavities

Effect of Er3+ concentration on spectral characteristic and 2.79 μm laser performance of Er:YSGG crystal

Evaporation characteristics of Er3+-doped silica fiber and its application in the preparation of whispering gallery mode lasers

High quantum efficiency and high concentration erbium-doped silica glasses fabricated by sintering nanoporous glasses

Eye-Safe Erbium Glass Laser Transmitter Study Q-Switched with Cobalt Spinel

Demonstration of Yb3+-doped and Er3+/Yb3+-codoped On-Chip Microsphere Lasers

High ytterbium concentration Yb/Al/P/Ce co-doped silica fiber for 1-μm ultra-short cavity fiber laser application

Quantitatively Identifying the Upconversion Luminescence Mechanisms of Er3+:NaYF4 Nanocrystals in Aluminosilicate Glass Ceramics under Femtosecond Laser Field

Upconversion in Highly Doped Er~(3+)-Yb~( 3+) Fiber Pumped by Ti∶Sapphire Laser at 800 nm

LD End-Pumped Er,Pr:GYSGG Single Crystal Fiber Laser As a Potential Mid-Infrared Seed Source Applied in Radiation Environment

Evaporation characteristics of Er$^{3+}$ doped silica fiber and its application in the preparation of whispering gallery mode lasers

An Erbium-doped fiber laser based on a 3×3 microfiber coupler

Enhanced radiation resistance of Er3+/Yb3+ co-doped high-phosphorus silica glasses and fibers via phase-interface engineering

Effect of upconversion on Er3+-Yb3+ co-doped phosphate glass passively Q-switched laser

Quantitatively identifying the upconversion luminescence mechanisms of Er 3+ :NaYF 4 nanocrystals in aluminosilicate glass ceramics under femtosecond laser field

Experimental study and theoretical simulation for high gain compact Er<sup>3+</sup>-Yb<sup>3+</sup>-codoped fiber laser

High-power continuous-wave mid-infrared 2.8 μm Er-doped fiber lasers: A review

Influence Of Cr3+ Concentration On The Spectroscopy And Laser Performance Of Cr,Er:Ysgg Crystal