Laser Texture Manufacturing on Ti6Al4V Surface and Its Dry Tribological Characteristics

Lian Feng,Zhang Huichen,Pang Lianyun
DOI: https://doi.org/10.3969/j.issn.0254-0150.2011.09.001
2011-01-01
Abstract:Line textured,grid textured and dot textured Ti6Al4V surfaces were manufactured by laser.Surface roughness and cross-section hardness were characterized and measured.The effects of textured surface manufacturing of specimens on their dry tribological characteristics were evaluated by CETR Universal Micro-Tribometer.Topography and worn surface were observed with optical microscopy and scanning electron microscopy.The results show that the hardness of specimens increases significantly after the treatment of laser textured manufacturing.The hardness of dot textured specimens is the highest and that of line textured specimens is the lowest.For proper spacing,the friction coefficients of dot textured specimens are smaller than that of polished specimens.However,the friction coefficients of line and grid textured specimens are larger than that of polished specimens.SEM photographs indicate that the dot in textured surface can capture and hold wear debris.
What problem does this paper attempt to address?