Abstract:The present work investigates the effect of cantilever deformation and tip-sample contact area on the performance of atomic force microscopy (AFM)-based scratching tests. Nanoscratching tests are carried out using a pyramidal diamond tip on aluminum alloy surfaces. Three typical AFM cantilever deformation states are illustrated, and the actual normal loads applied on the surface of the sample are obtained using a new method. A theoretical model for AFM-based nanoscratching using a three-sided pyramidal tip is also established to calculate the effect of the tip-sample contact area for different scratching directions. The corresponding theoretical normal loads can be obtained with this model. Experimental and theoretical results are compared for the normal loads at an expected machined depth, with different scratching directions. The contact length between the chip and the rake face of the tip is found to be the key factor leading to an increase in the tip-sample contact area. This results in an actual normal load larger than the theoretical normal load at an expected depth, especially in the face-forward scratching direction. Similar variation in the normal load is observed in the edge-and sideface-forward scratching directions. The scratching direction has little effect on the depth of the scratched grooves. Comparing the actual normal load with the set normal load along different scratching directions reveals that the cantilever deformation in different scratching directions has little effect on the scratching process. VC 2013 American Vacuum Society.

Analysis of lateral force contribution to the topography in contact mode AFM

Molecular Dynamics Simulation of Form Measurement Process of Soft Materials Using Atomic Force Microscope

Improved Calibration Method For Lateral Force Of The Cantilever Deflection Force Sensor In Atomic Force Microscope

A Novel Topography and Elasticity Synchronous Measure Approach With an AFM

The role of topography and friction for the image contrast in lateral force microscopy

On Micro Scanning Forces under the Coupling Deformation of Atomic Force Microscope Probe

Detection of Tip Convolution Effects Based on Lateral Force Analysis

Edge Effects and Coupling Effects in Atomic Force Microscope Images

Application of Triangular Atomic Force Microscopy Cantilevers to Friction Measurement with the Improved Parallel Scan Method.

Operation Mode of AFM Considering Friction and Slope of Sample Surface

Afm with the Slope Compensation Technique for High-Speed Precision Measurement of Micro-Structured Surfaces

Thermo-mechanical responses of a surface-coupled AFM cantilever.

Simulation and experimental analysis of tip response of tapping mode atomic force microscope

An operating method with lateral scan for reducing the error in topography caused by the tip-sample angle in atomic force microscopy.

Characterization of Topography and Adhesion of Sidewall Using an Orthogonal Cantilever Probe

Measurement of Laterally Induced Optical Forces at the Nanoscale

Investigation of the topography-dependent current in conductive AFM and the calibration method

Effect of Cantilever Deformation and Tip-Sample Contact Area on AFM Nanoscratching

Improved Parallel Scan Method for Nanofriction Force Measurement with Atomic Force Microscopy

Frequency-domain Analysis Method for Analyzing and Improving the Steady-State Characteristics of Microcantilever in Tapping-Mode Atomic Force Microscopy

Effect of contact stiffness on wedge calibration of lateral force in atomic force microscopy.