Abstract:In this paper, a novel point grinding wheel (NPGW) with coarse grinding area angle θ is proposed. According to earlier studies, this type of grinding wheel has the advantages of high grinding efficiency, a long service life, and very little surface roughness generated. The contact zone between the grinding wheel and workpiece is modified by the addition of the NPGW with the coarse grinding area angle θ and the inclining angle α of the point grinding process, and as a result, the grinding zone temperature is also altered. Using the finite element method, the grinding zone temperature can be simulated based on the theory of grinding heat generation and distribution, and the triangular heat source distribution model. From this, the distribution of the point grinding temperature field and influence of different grinding parameters on the grinding zone temperature were obtained. To verify the simulation, thermocouple measurements for different NPGWs were taken during the grinding experiments. The simulation provides an auxiliary and predictive method for the actual process. Moreover, an L16(45) orthogonal experiment was designed. Analyzing this range, primary and secondary factors affecting grinding zone temperature, and the optimum combination of parameters for reducing the grinding zone temperature, are determined. Finally, the grinding heat can affect the quality of the workpiece subsurface; therefore, the influence of the various parameters on subsurface quality, including metallographic structure, work hardening, and residual stress, was studied. In conclusion, the NPGW and point grinding process can reduce the degree of work hardening and residual stress of the subsurface of the workpiece, and it was demonstrated that the residual stress changes from compressive to tensile with increasing depth.

An investigation of chip types in grinding

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Study on the grinding of Inconel 718

Experimental investigation on grinding-induced surface damage of Fiber Reinforced Ceramic Matrix Composites

Theoretical Generalization and Research on the Mechanism of the Unsteady-State Grinding Technique

A Study On Grinding Quantities Using Chip Volume

Analysis of spherical chips after grinding

Experimental Investigation on High-Shear and Low-Pressure Grinding Process for Inconel718 Superalloy

Effect of Grinding Wheel Ultrasonic Vibration on Chip Formation in Surface Grinding of Inconel 718

Comparative Investigation on Grindability of Inconel 718 Made by Selective Laser Melting (SLM) and Casting

Research on the Ductile Chip Formation in Grinding of Brittle Materials

Study on Grindability of Inconel 718 Superalloy Fabricated by Selective Laser Melting (SLM)

Time Dependent Behavior Analysis of Inconel 718 in High Speed Grinding Process

Analysis of chip size distribution using image processing technology to estimate wear state of cylindrical grinding wheel

Investigation of the grinding temperature and subsurface quality of a novel point grinding wheel

Analytical Modelling of Both Parallel and Cross Grinding with Arc-Shaped Wheel for Grinding-Induced Damage and Grinding Force

Analysis of Chip Formation Mechanism in Mill-grinding of SiCp/Al Composites

Comprehensive Investigations into the Force and Thermal Characteristics of Belt Grinding Inconel 718 under Constant Normal Forces

Chip Formation Mechanism of Inconel 718: A Review of Models and Approaches

Experimental and Finite Element Analysis of the Formation Mechanism of Serrated Chips of Nickel-Based Superalloy Inconel 718

Investigation of Cutting Mechanism and Residual Stress State with Grooved Grinding Wheels