Abstract:This paper presents an experimental and theoretical study of surface generation in the ultra-precision grinding of hard and brittle materials. The study takes into account the material properties, the relative vibration between the grinding wheel and the workpiece, the machining parameters and the phase shift of the grinding process. The Taguchi approach is employed to study the influence of machining parameters on the surface quality and shows that the feed speed and rotational speed of the workpiece are key factors. Experiments have been conducted to study individual variables, and the results further show that the feed rate and the cross-feed distance have a significant effect on surface generation. It is found that the spirals around the central area of the workpiece are the primary mechanism for surface generation, which originates from the synchronous relative tool-work vibration. The integral part of the ratio of the rotational speed of the grinding wheel to rotational speed of the workpiece determines the number of spirals and its fractional part controls the spiral geometry. A theoretical model for predicting the single spiral generation has been developed to explain the accumulation of the phase shift and the geometry. The changeable feed speed near the end of grinding is also modelled, revealing the approximate straight lines around one circle in the central region. The simulated results indicate that the theoretical models and the ground surfaces are in close agreement. The scallop-height model is developed to calculate the influence of phase shift on surface quality, and it is found that the phase shift near the medium value can effectively improve surface quality. Finally, a comparison of different surface generation mechanisms in grinding mould steel, tungsten carbide (WC) and reaction bonded silicon carbide (RB-SiC) is made. It is interesting to note that the Spanzipfel effect contributes to the surface generation not only on ductile materials such as mould steel but also on brittle materials such as WC and RB-SiC. The Spanzipfel effect is the most significant in grinding mould steel. For WC and RB-SiC, the ground surface contains both a ductile region and a brittle region in the form of micro-fractures.

Analysis of spherical chips after grinding

Studies on the Surface Quality of the Unsteady-State Grinding Technique

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

A Study On Grinding Quantities Using Chip Volume

Experimental Investigation of Wearing Grinding Wheels After Machining Sintered Carbide

Characterization of High-Speed Alumina Abrasive Grinding Wheel

An investigation of chip types in grinding

The Statistical Analysis of Granulometric Composition and Microgeometrical Indicators of Abrasive Grains of Grinding Wheels for Rough Machining

An experimental and theoretical analysis of surface generation in the ultra-precision grinding of hard and brittle materials

Structure and Properties of Bakelite Bonded Grinding Wheels

Analysis of chip size distribution using image processing technology to estimate wear state of cylindrical grinding wheel

Experimental Analysis of Ductile Cutting Regime in Face Milling of Sintered Silicon Carbide

Machining of grinding wheels with single point cutting tools.

Investigation on the effect of grinding wheel for grinding of AISI D3 tool steel under different conditions

Effect of the Axial Profile of a Ceramic Grinding Wheel on Selected Roughness Parameters of Shaped Surfaces Obtained in the Grinding Process with a Dual-Tool Grinding Head

Experimental study on grinding 2.5D C/SiC composites by electroplated grinding wheel with ordered abrasive clusters

Influence of Thermal-mechanical Coupling of Single Particle on Grinding Surface Roughness

Analysis Of Alumina Particles Size And Shape Formation From Developed Planetary Ball Mill

Effect of single/multi-particle grinding parameters on surface properties of bearing steel GCr15

Research on Microscopic Grain-Workpiece Interaction in Grinding through Micro-Cutting Simulation, Part 2: Factorial Study

Effects of a New Type of Grinding Wheel with Multi-Granular Abrasive Grains on Surface Topography Properties after Grinding of Inconel 625