Abstract:The grain-refining behaviors of 20Mn2 steel containing ZrC particles compressed with various degree of deformation (30%80%) at different temperature (8501150) were investigated by thermal simulating test.Microstructure analyses indicate that the role of ZrC particles as deformation nucleus and recrystallization nucleus enhances the nucleation rate of dynamic recrystallization of austenite and leads to grain refined with size of 34μm even when deformed at high temperature such as 1150 and 1050,further more that the ZrC particles as deformation nucleus increases concentrated degree of the located deformation in austenite makes deformation-induced ferrite transformation take place in advance at a higher temperature(950).Because a super-refined grain increases the critical cooling rate for obtaining martensite,the water-quenched microstructure deformed at the employed temperature developes from martensite to bainite and deformation-induced ferrite.Hardness analyses indicate that the hardening effect created by grain super-refining and strain is enough to offset the soft effect led by decrease in amount or even disappearance of martensite and bainite,also it can further increases the hardness of 20Mn2 steel to a higher value while the grain refining creates a bigger effect than the strain does.Analyses on the stress and strain in the deformation indicate that the austenite recrystallization causes a decrease in deformation resistance when deformed at 1150 and 1050,while deformation induced ferrite transformation plays the same role when deformed below 950.

Research Progress of Deformation Induced Ferrite Transformation at ZrC/Austenitic Interface

MICROSTRUCTURE REFINEMENT OF DEFORMATION-ENHANCED TRANSFORMATION IN LOW CARBON STEEL

Effect of Deformation on Microstructure Refinement of an Ultrahigh Carbon Steel

Deformation enhanced ferrite transformation in plain low carbon steel

Effect of ZrC Particle on Grain Refining and Properties of Low-Carbon and Low-Alloy Steel

Ultra-fine ferrite formation during deformation of undercooled austenite in a low carbon steel

Strengthening Effect of ZrC Particles on Low-Carbon Microalloy Steel

Analysis of textural features during ferrite refinement by deformation-enhanced transformation in a low carbon steel

INFLUENCE OF C AND Mn CONTENT OF LOW CARBON STEEL ON ULTRA-FINE FERRITE MICROSTRUCTURE FORMATION DURING ANNEALING AFTER DEFORMATION-ENHANCED TRANSFORMATION

Dilatometric Research on Pearlite-to-austenite Transformation of Fe–1C–1.44Cr Low-Alloy Steel

Effects of Deforming Temperature on Grain-refining of 20Mn2 Steel Containing ZrC Particles

Dynamic recrystallization of ferrite in a low-carbon steel

MICROSTRUCTURAL REFINEMENT OF STRUCTURAL STEELS

Effect of Adding Ceramic Particles on Grain Refining in Low Carbon Microalloy Steel

Ferrite Grain Refinement Through Strain Induced Transformation in SPHC Steel

Microstructural Refinement and Strain Hardening Behavior in Low-Density Ultrafine Pearlite Steel

Mechanisms of Microstructure Evolution During Deformation of Undercooled Austenite in a Low Carbon Steel

Austenite/Ferrite Interface Migration and Alloying Elements Partitioning: an Overview

Dynamic recrystallization of ferrite during deformation at temperatures below A(c1) in a low carbon steel

Ultrafine Grain Ferrite Transformed from Fine Austenite Grains Produced by Dynamic Reversal Transformation

STRAIN-ENHANCED TRANSFORMATION AND FERRITE DYNAMIC RECRYSTALLIZATION OF PLAIN LOW CARBON STEEL IN SUCCESSIVE HOT DEFORMATION