Abstract:This paper reports experimental results of cyclic behaviours of eight concrete-filled steel tubular (CFT) columns after exposure to fire under sustained axial load. The specimens were heated by a stackable electrical furnace and blowing liquefied petroleum gas fire into the furnace simultaneously in order to simulate the real fire attack. The furnace heating can be controlled easily and safely in such a hybrid heating method using gas and electricity that the average temperature in the furnace followed as closely as possible the ISO-834 standard fire curve. After the CFT columns had been axially loaded and heated for a specified duration of time, the specimens were cooled down to room temperature according to the ISO-834 fire standard while the axial load was kept constant. Finally, the columns were subjected to lateral cyclic loading under constant axial load. The sustained pre-load led to significant residual deformations of CFT columns during the cooling phase. Two columns were found to have suffered local buckling of steel tube and three columns have suffered steel weld rupture during the fire exposure. Therefore, it is recommended that more than two vent holes or vent holes with larger diameter should be used in a CFT column and engineers should pay much attention to reasonable selection and construction of steel sections. Compared with the fire-damaged columns without pre-load and that at room temperature, the post-fire ductility and energy absorption capacity of CFT with pre-load had no obvious deterioration and the axial load level had no obvious influence on the residual strength of fire-damaged CFT. The experimental results can provide a basis for fire-damage assessment of CFT columns. (C) 2010 Elsevier Ltd. All rights reserved.

Tests on Impact Behaviour of Micro-Concrete-filled Steel Tubes at Elevated Temperatures Up to 400°C

Impact Behaviours Of Concrete-Filled Steel Tubular Stub Column At Elevated Temperatures

Tests on impact behaviour of concrete-filled steel tube after exposure to high temperatures

EXPERIMENTAL RESEARCH ON IMPACT BEHAVIOR OF CONCRETE-FILLED STEEL TUBE AT ELEVATED TEMPERATURES

Experimental research on impact-resistant capacity of concrete filled steel tube under high temperature

Behavior Of Concrete Filled Tubes And Confined Concrete Filled Tubes Under High Speed Impact

Behaviour of CFT and CCFT columns under impact loads

Strength of Concrete Filled Steel Tubes under High-Strain Rate Loading

Flexural behavior of concrete-filled circular steel tubes under high-strain rate impact loading

Experimental study on dynamic behavior of concrete at elevated temperatures

Axial Impact Behaviors of Stub Concrete-Filled Square Steel Tubes

Impact Behaviors of CFT and CFRP Confined CFT Stub Columns

Effects of Sustained Pre-Load on Residual Strength and Stiffness of Concrete-Filled Steel Tube after Exposure to High Temperatures

Axial Impact Behavior of Confined Concrete Filled Square Steel Tubes Using Fiber Reinforced Polymer

Cyclic Behaviours Of Concrete-Filled Steel Tubular Columns With Pre-Load After Exposure To Fire

Experimental Studies on Concrete Filled Steel Tubes under High Strain Rate Loading

Effects of sustained axial load and cooling phase on post-fire behaviour of concrete-filled steel tubular stub columns

Post-Earthquake Fire Resistance of Circular Concrete-Filled Steel Tubular Columns

Low Cyclic Fatigue Performance of Concrete-Filled Steel Tube Columns

Fire resistance and load-bearing capacity of concrete filled fire-resistant steel tubular columns with circular cross-section

Effects of preload and cooling phase on post-fire behaviour of concrete-filled steel tubular stub columns