Laser electron storage ring for ttx∗
Haisheng Xu,Y. You,Wenhui Huang,Chuanxiang Tang,Lixin Yan,D. Jehanno,F. Zomer
2013-01-01
Abstract:Tsinghua Thomson scattering X-ray (TTX) source, proposed by Tsinghua University, is a hard x-ray source with multi-application in condensed matter physics and other applications. The TTX is composed of an S-band photocathode RF gun and a SLAC type 3m travelling wave Linac, and a femto-second tera-watt laser system. The TTX source is in operation. To extend the capability of TTX, we plan to design a ring based system to increase the average photon flux. In this paper, we report the design of the 4.8 m electron storage ring and optical cavity, expected performance, and future prospects. INTRODUCTION Inverse Compton Scattering is a physical effect which can transfer energy from electrons to photons. Hard xray, which is in dozens of keV range, can be generated by head-on collision between low energy photons and MeV electrons. Tsinghua Thomson scattering X-ray source was started in 2001, which consists of an S-band photocathode RF gun, an S-band 3m SLAC type travelling wave linac, and a tera-watt laser system [1]. In previous experiments, the number of generated X-ray photons, which is measured with MCP, is about 1 × 10photons/pulse [2]. The repetition frequency is 10 Hz. For generating stable x-ray output and increasing the photon flux, a compact electron storage ring and an optical cavity are proposed. In this scheme, the electron beam is stored in a small ring while laser pulses are stored and enhanced in an optical cavity. The repetition frequency is the same as the revolution frequency of the electron beam in the ring of the order of magnitude of tens of MHz. In this paper, we present the current design of the compact electron storage ring and optical cavity. THE ELECTRON STORAGE RING DESIGN Lattice We propose to use a 4-dipole scheme in the design of this 4.8 m ring. The bending radius of dipoles is 0.25 m. Two quadrupoles are put opposite to each other to change the damping partition number. As shown in Fig. 1 and ∗Work part supported by NSF PHYS 1205431 and DOE DE-FG0212ER41800 † xhs05@mails.tsinghua.edu.cn Fig. 2, both betatron tune and horizontal damping partition number can be varied by adjusting the strength of the quadrupoles and the edge angle of dipoles. Tune should be chosen carefully in order to avoid the harmful linear and nonlinear resonances. 0 0.5 1 1.5 2 0 0.5 1 1.5 2 Qx Q z Colorbar means K 1Q =0[m]~40[m] 0 5 10 15 20 25 30 35 40 Edge Angle=33 Edge Angle=35 Edge Angle=37 Edge Angle=39 Edge Angle=41 Figure 1: Tune diagram by changing the edge angle of 0 5 10 15 20 25 30 35 40 −0.2 0 0.2 0.4 0.6 0.8 1 1.2 1.4 1.6