Abstract:This paper describes the radio frequency (RF) measurement and tuning result of a 13 MeV Alvarez-type drift tube linac (DTL) for a compact pulsed hadron source (CPHS) at Tsinghua University. The design, machining, assembly, and alignment of the DTL are presented for integrity. The CPHS project consists of a high-current proton linac (13 MeV, 16 kW, peak current of 50 mA, 0.5 ms pulse width at 50 Hz), a neutron target station, a small-angle neutron scattering instrument, and a neutron imaging/radiology station. The linac contains an electron cyclotron resonance ion source, a low energy beam transport line, a four-vane radio frequency quadrupole (RFQ) accelerator, an Alvarez-type DTL, a high energy beam transport line, and a RF power supply and distributor. Construction on the CPHS started in June 2009, and the CPHS has provided 2000 h since 2013 to users with the neutrons produced by the 3 MeV proton beam from the radio frequency quadrupole bombarding on the beryllium target as an achievement of its mid-term objective. Presently, the tuning of the assembled DTL cavity has been completed successfully. The 4.3-m-long DTL consists of 40 accelerating cells, among which 39 full-length drift tubes (DTs) are suspended inside the cavity, and two half-length DTs are mounted inside the two end flanges of the cavity. Each DT contains a permanent magnet quadrupole. Thirteen post couplers and nine tuners are available for the tuning of the field. The relative error of the field after tuning is within ±1.6%, with a tilt sensitivity within ±33%/MHz in all cells. The beam energy will reach its designed value of 13 MeV after the DTL is installed in the beam line downstream the 3 MeV RFQ accelerator.

Study and Design of the Coupled Cavity with Ladder RFQ and IH DTL Structure for Transportable Neutron Source

Design of a compact RFQ linac for the transportable neutron source

Physics Design Of A Coupled Rfq-Dtl Cavity For A Compact Neutron Source

RF Electromagnetic Design and Field Tuning Study of the Coupled Ladder RFQ-IH DTL Structure

Development and cold-test of an RFQ-DTL coupled cavity

Design of the Input Power Coupler for Boron Neutron Capture Therapy Drift Tube Linac

Design and experiments of a compact electrostatic low energy beam transport with a double Einzel-lens for a transportable neutron source

Beam dynamics design and error study of the coupled structure with ladder RFQ and IH-DTL

Design and Cold Measurements of a Coupled RFQ-SFRFQ Cavity

Design and beam dynamics simulation of an 8 MeV compact accelerator-driven neutron source

The Study and Design of a Deuteron Drift Tube Linear Accelerator for Middle Energy Neutron Source

Development of a Compact 325 MHz Proton Interdigital H-mode Drift Tube Linac with High Shunt Impedance

Beam Dynamics Design for a Compact Accelerator-Driven Neutron Source

Beam Dynamic Design and Study of a Linac with Variable Output Energy for an AB-BNCT Facility

Proposal and design of 81.25 MHz heavy ion drift tube linacs for BISOL

Design of a CW linac for the Compact Intense Fast NEutron Facility

IH-DTL Design with Modified KONUS Beam Dynamics for a Synchrotron-Based Proton Therapy System

Design and study of a continuous wave RFQ for the BISOL high intensity deuteron driver linac

Design of a 162.5 MHz Superconducting Radio-Frequency Quadrupole for High-Intensity Proton Acceleration

Radio frequency measurement and tuning of a 13 MeV Alvarez-type drift tube linac for a compact pulsed hadron source