Abstract:TiO2-diatomite photocatalysts were prepared by sol-gel process with various pre-modified diatomite. In order to obtain diatomite with different surface characteristics, two modification approaches including calcination and phosphoric acid treatment on the micro-structure of diatomite are introduced. The photocatalysts were characterized by XRD, XPS, nitrogen adsorption-desorption isotherms and micromorphology analysis. The results indicate that, compared with pure TiO2, the anatase-to-rutile phase transition temperature of TiO2 loaded on diatomite carrier is significantly increased to nearly 900 degrees C, depending on the different pretreatment method of diatomite. The photocatalytic activities of different samples were evaluated by their degradation rate of methyl orange ( MO) dye under UV and visible-light irradiation. The samples prepared by phosphoric acid pretreatment method exhibit the highest photocatalytic activity. After 90 min of UV irradiation, about 90% of MO is decomposed by the best effective photocatalyst. And after 8 h visible-light irradiation, nearly 60% of MO is decomposed by the same sample. Further mechanism investigation reveals that the H3PO4 pretreatment process can obviously change the surface features of diatomite carrier, cause the formation of Si-O-Ti bond, increase the binding strength between TiO2 and diatomite, restrain crystal growth of loaded TiO2, and thus form thermal-stable meso-porous structure at the granular spaces. It helps to build micro-, meso- and macro-porous hierarchical porous structure in TiO2-diatomite, and improves the charge and mass transfer efficiency during catalyzing process, resulting in the significantly increased photocatalytic activity of TiO2-diatomite pretreated by phosphoric acid. (C) 2014 Elsevier B. V. All rights reserved.

Study on the Preparation of TiO2/SiO2 Composite Powder and Its Photocatalytic Activity

Preparation of TiO_2/SiO_2 and Photo-Catalytic Degradation of Methyl-Orange

Preparation and Properties of TiO2/Bentonite Composite Photocatalytic Materials at Room Temperature

Preparation of TiO2/SiO2 Composite by Chemical Coating Method

Study on Preparation and Photocatalytic Properties Oftio2 /sio2 Composite Powders

Study on the Preparation and Photocatalytic Properties of Au/TiO2 Composite Fibers

Preparation and Photocatalytic Properties of Fe(III)-Grafted TiO<sub>2</sub> Nano-Composite Powders

The Effect of Calcination Temperature on the Structure and Activity of TiO2/SiO2 Composite Catalysts Derived from Titanium Sulfate and Fly Ash Acid Sludge

Preparation and Crystallization Behavior of SiO2-TiO2 Photo-Catalytic Films

Preparation and Photocatalytic Activity of TiO<sub>2</sub>/Fe<sub>2</sub>O<sub>3 &Lt;/sub>nanocomposite

Preparation and Properties of TiO2/illite Composites Synthesized at Different Hydrothermal Ph Values

Preparation of Fe2o3/Srtio3 Composite Powders and Their Photocatalytic Properties

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite

Composites of TiO2 pillared sericite: Synthesis, characterization and photocatalytic degradation of methyl orange

A High-Stability Silica–clay Composite: Synthesis, Characterization and Combination with TiO2 As a Novel Photocatalyst for Azo Dye

Photocatalytic Properties of TiO<sub>2</sub> and Fe(III)-, Z(II)- and Si(IV)- Doped TiO<sub>2</sub> Nanopowders Synthesized by Sol-Gel

Room-Temperature Preparation of TiO2-SiO2 Composite Film and Its Properties

Hydrolytic Modification of SiO2 Microspheres with Na2SiO3 and the Performance of Supported Nano-TiO2 Composite Photocatalyst

Preparation and Photocatalysis Performance of BaSO4/TiO2 Composite Particles

Effect of calcination temperature on the structure and properties of SiO2 microspheres/nano-TiO2 composites

Facile fabrication of TiO2-SiO2-C composite with anatase/rutile heterostructure via sol-gel process and its enhanced photocatalytic activity in the presence of H2O2