Abstract:TiO2-diatomite photocatalysts were prepared by sol-gel process with various pre-modified diatomite. In order to obtain diatomite with different surface characteristics, two modification approaches including calcination and phosphoric acid treatment on the micro-structure of diatomite are introduced. The photocatalysts were characterized by XRD, XPS, nitrogen adsorption-desorption isotherms and micromorphology analysis. The results indicate that, compared with pure TiO2, the anatase-to-rutile phase transition temperature of TiO2 loaded on diatomite carrier is significantly increased to nearly 900 degrees C, depending on the different pretreatment method of diatomite. The photocatalytic activities of different samples were evaluated by their degradation rate of methyl orange ( MO) dye under UV and visible-light irradiation. The samples prepared by phosphoric acid pretreatment method exhibit the highest photocatalytic activity. After 90 min of UV irradiation, about 90% of MO is decomposed by the best effective photocatalyst. And after 8 h visible-light irradiation, nearly 60% of MO is decomposed by the same sample. Further mechanism investigation reveals that the H3PO4 pretreatment process can obviously change the surface features of diatomite carrier, cause the formation of Si-O-Ti bond, increase the binding strength between TiO2 and diatomite, restrain crystal growth of loaded TiO2, and thus form thermal-stable meso-porous structure at the granular spaces. It helps to build micro-, meso- and macro-porous hierarchical porous structure in TiO2-diatomite, and improves the charge and mass transfer efficiency during catalyzing process, resulting in the significantly increased photocatalytic activity of TiO2-diatomite pretreated by phosphoric acid. (C) 2014 Elsevier B. V. All rights reserved.

Photocatalytic Properties of TiO<sub>2</sub> and Fe(III)-, Z(II)- and Si(IV)- Doped TiO<sub>2</sub> Nanopowders Synthesized by Sol-Gel

Influence of Fe2o3 Doping on Morphology and Photocatalytic Activity of Tio2 Prepared by Adsorption Phase Synthesis

Photocatalytic Activity of Iron Doping Tio2 Prepared by Several Methods

Visible-Light-Driven Titania/Silica Photocatalyst Co-Doped with Boron and Ferrum

PREPARATION OF IRON-DOPED TITANIA NANOCRYSTALLINE GRAINS AND ITS PHOTOCATALYTIC PROPERTY

Nanocrystalline Fe/TiO2 Visible Photocatalyst with a Mesoporous Structure Prepared via a Nonhydrolytic Sol-Gel Route

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite

Photonic, and Photocatalytic Behavior of Tio2 Mediated by Fe, Co, Ni, N Doping and Co-Doping

Preparation and Photocatalytic Activity of TiO<sub>2</sub>/Fe<sub>2</sub>O<sub>3 &Lt;/sub>nanocomposite

Preparation Of Fe3+-Doped Tio2 Nanoparticles And Their Photocatalytic Activities

Effect of the P/Ti Ratio on the Visible-Light Photocatalytic Activity of P-Doped Tio2

P-doped TiO_2 Immobilized Diatomite and Its Photocatalytic Performance under Visible Light

Preparation and Photocatalytic Properties of Fe(III)-Grafted TiO<sub>2</sub> Nano-Composite Powders

Preparation and Property of Fe~(3+)-doped TiO_2 Nanocrystal Sol

Influence of Doping the Nanosized SiO2 Powder on Structure and Activity of Photocatalytic Films

Effect of Fe doping on crystalline phase, structure and photocatalytic properties of TiO2 thin films

The effects of additive on properties of Fe doped TiO2 nanoparticles by modified sol-gel method

Structure Influence of Fe~(3+)-TiO_(2)/SiO_(2) Film on the Photocatalytic Properties

Preparation and Photocatalytic Properties of Mo-doped TiO2

Structure influence of Fe3+ doped TiO2/SiO2 film on the photocatalytic properties

Synthesis and Photocatalysis Properties of Sulfur Doped Nanocrystalline TiO2 Photocatalyst