Abstract:Modern highly sensitive and selective sensors are able to determine biologically active substances, which makes this direction one of the most popular areas of analytical chemistry. The study featured the electrochemical properties of new fiber materials based on single-wall carbon nanotubes with prospects of using them in the voltammetry of ascorbic acid. The authors developed a new technology to synthesize films from disordered single-wall carbon nanotubes by chemical vapor deposition. Fibers were produced from a solvent by wet-pulling of single-wall carbon nanotubes networks. Thin films of randomly oriented single-wall carbon nanotube bundles were deposited downstream of a floating aerosol CVD reactor, which included a high temperature furnace with a quartz tube. The synthesis of the single-wall carbon nanotube samples was performed at 825°C. Ethanol served as carbon source while ferrocene was used as catalyst precursor. The single-wall carbon nanotubes were collected on a nitrocellulose filter in the form of films with transmittances of 10% in the middle of the visible wavelength (550 nm). The method was optimized to involve air annealing at 300–320°C and a treatment with strong inorganic acids, i.e., HCl, HNO3 + H2SO4. The voltammetric curves recording included background electrolyte, scan rate, and preconditioning. These parameters were selected experimentally to obtain the maximal sensor response to ascorbic acid content. The anodic peak of ascorbic acid in the phosphate buffer electrolyte (pH 6.86) was observed at a potential of +0.2 V. The current and peak area of ascorbic acid oxidation depended neither on the time nor on the conditioning potential of the sensor. The linear dependences of these parameters on the concentration of ascorbic acid stayed within 50–500 μmol/L (8.8–90 mg/L) at a scan rate of 0.1 mV/s. The single-wall carbon nanotube microsensor had a length of 0.5 cm and an average width of 400 μm. Its sensitivity was two times as high as that of a disk glassy carbon electrode with a diameter of 5 mm. The experimental sensors proved effective in determining ascorbic acid in food products, pharmaceuticals, and biological fluids.

Electrochemistry and Voltammetric Determination of Tannic Acid on a Single-Wall Carbon Nanotube-Coated Glassy Carbon Electrode

Electrocatalytic Oxidation of Ascorbic Acid on Quaternized Carbon Nanotubes/Ionic Liquid-Polyaniline Composite Film Modified Glassy Carbon Electrode

Electrochemical aptasensor for the detection of tetracycline with multi-walled carbon nanotubes amplification

Layer-By-Layer Assembly of Poly(P-Aminobenzene Sulfonic Acid)/Quaternary Amine Functionalized Carbon Nanotube/P-Aminobenzene Sulfonic Acid Composite Film on Glassy Carbon Electrode for the Determination of Ascorbic Acid

Electrochemical Determination of Dopamine Using a Carboxyl-functionalized Carbon Nanotube-Modified Carbon Paste Electrode Doped with Polymeric Ferric Sulfate

Selective determination of trichloroacetic acid using silver nanoparticle coated multi-walled carbon nanotubes

Investigation of the electrocatalytic behavior of single-wall carbon nanotube films on an Au electrode

Carbon nanotube-modified electrodes for the simultaneous determination of dopamine and ascorbic acid.

Investigation of the Electrochemical and Electrocatalytic Behavior of Single-Wall Carbon Nanotube Film on a Glassy Carbon Electrode

Investigation on the Electrochemical and Electrocatalytic Behavior of Chemically Modified Electrode of Single Wall Carbon Nanotube Functionalized with Carboxylic Acid Group

A Sensitive Co-MOF/CNTs/SiO2 Composite Based Electrode for Determination of Gallic Acid

Electrocatalytic Oxidation Of Dopamine And Ascorbic Acid At Carboxylic Carbon Nanotube-Intercalated Graphite Electrode

Determination of tannic acid based on luminol chemiluminescence catalyzed by cupric oxide nanoparticles

Direct Electrochemistry of Catalase at a Gold Electrode Modified with Single‐Wall Carbon Nanotubes

A Novel Electrochemical Sensor Based on Carbon Nanotubes Array for Selective Detection of Dopamine or Uric Acid.

Synthesis, characterization and modification of functionalized pyrimidine stabilized gold nanoparticles on ITO electrode for the determination of tannic acid

Electrochemical Sensors Based on Single-Wall Carbon Nanotubes in Voltammetric Ascorbic Acid Tests

Functionalization of Carbon Nanotubes with Water-Insoluble Porphyrin in Ionic Liquid: Direct Electrochemistry and Highly Sensitive Amperometric Biosensing for Trichloroacetic Acid

Determination of Trace Tin by Voltammetry at an Nafion/MWCNT Modified Glassy Carbon Electrode

Preparation of Carboxylic Carbon Nanotubes Modified Electrode and Its Electrocatalytic Property on Vc

Amperometric Sensor Based on Carbon Nanotubes and Polycations for the Determination of Vitamin C