Abstract:Modern highly sensitive and selective sensors are able to determine biologically active substances, which makes this direction one of the most popular areas of analytical chemistry. The study featured the electrochemical properties of new fiber materials based on single-wall carbon nanotubes with prospects of using them in the voltammetry of ascorbic acid. The authors developed a new technology to synthesize films from disordered single-wall carbon nanotubes by chemical vapor deposition. Fibers were produced from a solvent by wet-pulling of single-wall carbon nanotubes networks. Thin films of randomly oriented single-wall carbon nanotube bundles were deposited downstream of a floating aerosol CVD reactor, which included a high temperature furnace with a quartz tube. The synthesis of the single-wall carbon nanotube samples was performed at 825°C. Ethanol served as carbon source while ferrocene was used as catalyst precursor. The single-wall carbon nanotubes were collected on a nitrocellulose filter in the form of films with transmittances of 10% in the middle of the visible wavelength (550 nm). The method was optimized to involve air annealing at 300–320°C and a treatment with strong inorganic acids, i.e., HCl, HNO3 + H2SO4. The voltammetric curves recording included background electrolyte, scan rate, and preconditioning. These parameters were selected experimentally to obtain the maximal sensor response to ascorbic acid content. The anodic peak of ascorbic acid in the phosphate buffer electrolyte (pH 6.86) was observed at a potential of +0.2 V. The current and peak area of ascorbic acid oxidation depended neither on the time nor on the conditioning potential of the sensor. The linear dependences of these parameters on the concentration of ascorbic acid stayed within 50–500 μmol/L (8.8–90 mg/L) at a scan rate of 0.1 mV/s. The single-wall carbon nanotube microsensor had a length of 0.5 cm and an average width of 400 μm. Its sensitivity was two times as high as that of a disk glassy carbon electrode with a diameter of 5 mm. The experimental sensors proved effective in determining ascorbic acid in food products, pharmaceuticals, and biological fluids.

Preparation of Carboxylic Carbon Nanotubes Modified Electrode and Its Electrocatalytic Property on Vc

Electrocatalytic Oxidation of Ascorbic Acid on Quaternized Carbon Nanotubes/Ionic Liquid-Polyaniline Composite Film Modified Glassy Carbon Electrode

Layer-By-Layer Assembly of Poly(P-Aminobenzene Sulfonic Acid)/Quaternary Amine Functionalized Carbon Nanotube/P-Aminobenzene Sulfonic Acid Composite Film on Glassy Carbon Electrode for the Determination of Ascorbic Acid

Electrochemical Determination of Dopamine Using a Carboxyl-functionalized Carbon Nanotube-Modified Carbon Paste Electrode Doped with Polymeric Ferric Sulfate

A Kit for Colorimetric VC Detection Combining with Bionic E-eye

A new voltammetric sensor for electrocatalytic determination of vitamin C in fruit juices and fresh vegetable juice using modified multi-wall carbon nanotubes paste electrode

Carbon nanotube-modified electrodes for the simultaneous determination of dopamine and ascorbic acid.

Amperometric Sensor Based on Carbon Nanotubes and Polycations for the Determination of Vitamin C

VOLTAMMETRIC BEHAVIOR OF ASCORBIC ACID AT Α-Cyclodextrin INCORPORATED CARBON NANOTUBES-COATED ELECTRODE

Electrocatalytic Oxidation Of Dopamine And Ascorbic Acid At Carboxylic Carbon Nanotube-Intercalated Graphite Electrode

Investigation on the Electrochemical and Electrocatalytic Behavior of Chemically Modified Electrode of Single Wall Carbon Nanotube Functionalized with Carboxylic Acid Group

Study on preparation and electrochemistry sensitivity of the carbon nanotubes modified electrode

Selective determination of trichloroacetic acid using silver nanoparticle coated multi-walled carbon nanotubes

Direct Electrochemistry of Catalase at a Gold Electrode Modified with Single‐Wall Carbon Nanotubes

Electrochemical Sensors Based on Single-Wall Carbon Nanotubes in Voltammetric Ascorbic Acid Tests

Voltammetric Determination of Trace Palladium by Carboxylic Carbon Nanotubes Modified Glass Carbon Electrode

Cobalt vanadate intertwined in carboxylated multiple-walled carbon nanotubes for simultaneous electrochemical detection of ascorbic acid, dopamine and uric acid

A Selective Voltammetric Method for Uric Acid Detection at Beta-Cyclodextrin Modified Electrode Incorporating Carbon Nanotubes

Investigation of the Electrochemical and Electrocatalytic Behavior of Single-Wall Carbon Nanotube Film on a Glassy Carbon Electrode

Electrocatalysis Study of Multi-Wall Carbon Nanotubes and Ferrocene/chitosan Composite Film Modified Glass Carbon Electrode

Investigation of the electrocatalytic behavior of single-wall carbon nanotube films on an Au electrode