Abstract:Electrical probe measurements are carried out at the scrape‐off‐layer (SOL) and divertor regions in order to investigate the characteristics of edge plasmas during H‐mode discharges in the Korea Superconducting Tokamak Advanced Research (KSTAR) device. Radial profiles of plasma parameters such as electron temperature Te, plasma density ne, and parallel flow velocity v‖ are measured by using a fast reciprocating Langmuir probe assembly (FRLPA) at the SOL region. From the FRLPA measurements, it is found that the decay length of temperature λTe and that of density λne are 2 ∼ 4 cm and 1 ∼ 3 cm, respectively. The magnitude of v‖ near the last closed flux surface (LCFS) is 4 ∼ 15 km/s. The radial flux due to edge turbulence at the SOL region is investigated by using spectra analysis on electrostatic fluctuation levels such as ion saturation current Ĩis and floating potential $ \tilde{\rm V}_f$ obtained from the FRLPA measurement. The value of the flux is estimated as ∼ 1020 particle m−2 s −1 near the LCFS. The poloidal distribution of the ion saturation current density jis is measured by fixed edge Langmuir probe array (ELPA) at the divertor region, and it is found that the positions of strike points from the ELPA measurement agree well with those reconstructed from the EFIT result using magnetic diagnostic data. From the spectrum analysis on the ELPA measurements at the divertor region during edge localized modes (ELMs) control in the H‐mode discharges, it is observed that the magnitude of $ \tilde{\rm j}_{is}$(ω) near strike point decreases when the ELMs are suppressed or mitigated (© 2013 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)

Thermo-hydraulic Analysis of the KSTAR Central Solenoid Model Coil

Hydraulics of KSTAR Central Solenoid Model Coil 2nd Campaign

Electric Probe Measurements at Edge Region During H‐Mode Discharges in KSTAR

Thermohydraulic Behaviors of Kstar Pf Superconducting Magnet System in Operation

Operating Temperature Margin and Heat Load in PF Superconducting Coils of KSTAR

AC Loss Analysis on the KSTAR PF1L Coil Based on the Long-Term Commissioning Shot Data

Thermohydraulic Characteristics of KSTAR Magnet System Using ITER-like Superconductors

Design Updates and Thermo-Hydraulic Analysis of K-DEMO CS Magnets

Structural Behavior of KSTAR CS Magnet During Plasma Operation

Development of a Conduction-Cooled HTS SMES

Performance of the Quench Detection System for the KSTAR CS Magnet System

Moving Mesh Application for Thermal-Hydraulic Analysis in Cable-in-conduit-conductors of KSTAR Superconducting Magnet

KS TAR PF 1 Coil Using the 4C Code

Analysis of Voltage Noises for the Reliability Improvement of the KSTAR CS Quench Detection

Dynamic Simulation on Flow Characteristics of KSTAR PF Magnet Cryogenic Network

Prediction of Mechanical Behavior of the KSTAR CS Magnet Based on PF Coil Currents

Operational Results of a Thermal-Hydraulic Quench Detection System for the KSTAR TF Superconducting Coils

Quench Detection System for the KSTAR Superconducting Toroidal Field Coil

Pressure Drop of CICC from Manufacturing Stage to Plasma Operation in KSTAR Superconducting Magnet System

Numerical Investigation of Quench Event in the Innermost Pair of the KSTAR Central Solenoids

Analysis of the Structural Behavior of the KSTAR TF Magnet for Safe Operation