Abstract:One of the investigation areas regarding the Ultrasonic Non-Destructive Test (UT-NDT) is the development of non-contact technologies like Air-Coupled UT, EMAT or UT generated by Laser. These technologies show several interesting advantages like no couplant needed or their application to the inspection of components with complex geometries and extreme surface conditions (temperature, roughness, radiation...). In the Laser Ultrasonics Techniques (LUS), ultrasound is generated by a pulsed laser that produces a thermal expansion of the surface where it impacts and generates vibrations at ultrasonic frequencies. These vibrations can travel through the inside of the material and its surface; and they are reflected, refracted or diffracted in the defects or discontinuities of the material. The disturbances generated by the interaction of the vibration with the defects are detected in another point of the material using a secondary detection system. Tecnatom is working with LUS technology since 2010, acquiring, installing and optimizing a laboratory system for its implementation in the inspection of metallic materials (aluminum, carbon steel and stainless steel). During this time, several works have been carried out to determine the scope of the technology as: initial study for the characterization of the waves generated by the laser; studies in test blocks without discontinuities to determine the experimental conditions in which ultrasonic disturbances are generated in thermo-elastic and ablative regime; simulations and microstructural studies of the pieces to determine both the structural state and the residual stresses caused by the incidence of the laser; inspection of blocks with artificial reflectors, both superficial and embedded, and set-up techniques to increase the amplitude of the detected signal; optimization of the detection system through the combination of technologies and identification of safety criteria, use and improvement of the system for validation use in industrial environments. In this work, Tecnatom presents the main conclusions of the development carried out to determine the capacities and limitations of the techniques based on Laser Ultrasonics for its application in Non-Destructive Testing for the inspection of metallic components.

Testing method for mechanical properties of materials based on laser-generated ultrasonic

A Study of Inner Crack Testing with the Laser Phased Array Method.

INTEGRATED TECHNOLOGY FOR DETECTION AND REPAIR OF MECHANICAL COMPONENT SURFACE FATIGUE MICROCRACKS USING PULSED LASER

Quantitative Detection of Surface Defect Using Laser-Generated Rayleigh Wave with Broadband Local Wavenumber Estimation

Detecting features of defect metal based on laser ultrasonic technique

Detection and Quantification of Damage in Metallic Structures by Laser-Generated Ultrasonics

Laser ultrasonic inspection for mechanical properties of materials at high temperature

Nondestructive characterization of mechanical properties on metallic and polymer plates using hybrid laser-air coupled ultrasonic techniques

Application of Air-Coupled Ultrasonic Nondestructive Testing in the Measurement of Elastic Modulus of Materials

Measurement of fiber reinforced composite engineering constants with laser ultrasonic

Width and Depth Gauging of Rectangular Subsurface Defects Based on All-Optical Laser-Ultrasonic Technology

Optical methods of laser ultrasonic testing technology in the industrial and engineering applications: A review

Off-epicentral measurement of laser-ultrasonic shear-wave velocity and its application to elastic-moduli evaluation

Measurement of Elastic Constants of Additive Manufactured Ti-6Al-4V by Non-contact Multi-mode Laser Ultrasonic System

Characterization of Elastic Modulus of Laser Cladding Coatings Using Laser Ultrasonic Method

Structural optimization of photoacoustic transducer with PDMS/CSNPs nanocomposite for fatigue crack detection using laser-induced nonlinear surface waves

Nondestructive testing of internal defects by ring-laser-excited ultrasonic

Nondestructive Evaluation of MEMS Devices by Laser Confocal Measurements

Non-destructive evaluation of non-uniform stress fields and subsurface stress gradients using ultrasonic waves

Laser generated Ultrasound System (LUS) and its application for the Non-Destructive Testing of metallic components

Specific Features of Nondestructive Testing of Polymer and Composite Materials Using Air-Coupled Ultrasonic Excitation and Laser Vibrometry