Abstract:A topological approach based on analysis of atomic size distributions has been developed and applied to multicomponent amorphous alloys with different glass-forming ability. The atomic size distributions were obtained by plotting atomic concentrations versus atomic radii of constitutive elements. Ordinary amorphous alloys with high critical cooling rates were found to have single-peak distributions with a concave downward shape. These amorphous systems have at least one alloying element with a smaller radius, and at least one alloying element with a larger radius relative to the base element. The concentration of an alloying element decreases rapidly as the difference in the atomic sizes of the base element and the alloying element increases. Atomic size distributions of Zr, Pd, or Ln-based bulk amorphous alloys, which have a critical cooling rate in the range of 1–100 K/s, have a completely different, concave upward shape with a minimum at an intermediate atomic size. The base alloying element in these alloys has the largest atomic size and the smallest atom often has the next-highest concentration. A model that explains the concave upward shape of atomic size distributions for the bulk amorphous alloys is suggested. This model takes into account that all alloying elements in bulk glass formers are smaller than the matrix element, and some of them are located in interstitial sites while others substitute for matrix atoms in a reference crystalline solid solution. The interstitial and substitutional atoms attract each other and produce short-range ordered atomic configurations that stabilize the amorphous state. According to this model, the critical concentration of an interstitial element required to amorphize the alloy increases with increasing size difference from the matrix atom.

Size effect on glass-forming ability in the AuTa system upon ion mixing

Study of Size Effect on Ni60Nb40 Amorphous Particles and Thin Films by Molecular Dynamic Simulations

Spontaneous Vitrification In The Au-Ta System With A Small-Size Difference

Fractal Patterns in Au–Ta Multilayer Films Upon Ion Beam Mixing

Interface Enhanced Glass Forming Ability under Ion Mixing/solid-State Reaction in an Immiscible Hf - Ta System

Chemical and interface effects on glass forming ability under ion mixing in ZrTa system of positive heat of formation

Effect of the atomic size distribution on glass forming ability of amorphous metallic alloys

Glass forming abilities of the Fe–Ta–(Zr, Ti) alloys studied by thermodynamic calculation and ion beam mixing

Glass Forming Ability In The Equilibrium Immiscible Ag-Ta System Studied By Molecular Dynamics Simulation And Ion Beam Mixing

Ion-mixing-induced Amorphization in an Immiscible Au - Mo System with a Small Size Difference

Effects of Ga,In additions of the Glass Forming Ability of Fe40Ni40P14B6 Eutectic Alloy

Ti-Au Metallic Glasses Formed by Ion Mixing

Irradiation-induced Alloying in an Immiscible TaTi System

Ion Mixing to Synthesize Amorphous and Metastable Crystalline Alloys in the Fe-Ta System

Microalloying effect in ternary Al-Sm-X (X=Ag, Au, Cu) metallic glasses studied by ab initio molecular dynamics

Structural phase transition in the Fe–Ta system studied by ion beam mixing

Formation of Non-Equilibrium Phases and Associated Structural Transition in the Pd-Ta System Induced by Ion Beam Mixing

Amorphous phase formation in the Ni–Ti–Ta system studied by thermodynamic calculation and ion beam mixing

Formation Of Amorphous Alloys By Ion Mixing And Its Thermodynamic And Atomistic Modeling In The Binary Metal Systems

Metastable alloys synthesized by ion mixing in immiscible Ti–Nb and Ti–Ta systems

Size effect on atomic structure in low-dimensional Cu-Zr amorphous systems