Abstract:As a result of increasing energy demands and accelerated environmental problems, there is an urgent need to improve the thermal efficiency of ultra supercritical (USC) power plants. To achieve this goal, advanced ultra-supercritical (A-USC) technologies with the main steam temperature of 700 similar to 750 degrees C and pressure of 35 MPa have been developed quickly in recent years. One of the most promising candidate Ni-based superalloys for the main steam pipe of 700 degrees C ultra-supercritical coal-fired power plants is Inconel 740H, which is a modified version of Inconel 740 developed by Special Metals Corp (SMC). Compared with IN740, the Ti/Al ratio in IN740H is lowered in order to stabilise the microstructure at long ageing times. In addition, the Nb content is lowered to improve the weldability. In this work, the microstructure evolutions, the nucleation and propagation mechanisms of microcracks in the nickel base superalloy Inconel 740H at 750 degrees C high temperature were studied by the self-developed in situ high temperature tensile stage inside a SEM. The results showed that under the uniaxial tensile stress at 22 degrees C room temperature and 750 degrees C high temperature conditions, the grain boundaries of Inconel 740H alloy are al-ways the most primary crack sources. The strength of grain boundaries is higher than that of grains under the room temperature, and the microcracks will be nucleated at the grains as well, but the relative strength of grain boundaries will be weaken under the high temperature, which makes the microcracks tend to nucleate at grain boundaries. The experimental results also showed that the influence of high temperature on the mechanical properties is very significant, the high temperature reducing the activate energy of slip and weakening the strength of the grain boundaries, so that more slip systems activated and the grain boundaries occurring bending and sliding deformation, so further enhance the ability of plastic deformation of alloy. However, the reduction of relative strength of alloy grain boundaries leads to microcracks nucleation and propagation more easily from grain boundaries and lower the yield strength and tensile strength of alloy.

RESEARCH ON ELEVATED-TEMPERATURE FRACTURE TOUGHNESS OF INCOLOY 800H MATERIAL FOR IN-SERVICE FURNACE TUBES

EXPERIMENTAL RESEARCH ON IMPACT BEHAVIOR OF CONCRETE-FILLED STEEL TUBE AT ELEVATED TEMPERATURES

EFFECT OF TEMPERATURE ON FRACTURE TOUGHNESS OF INCONEL 617B SUPERALLOY WELDED JOINT

Mechanical properties of butt weldments made with E5515-G electrodes at high temperature

Temperature dependence of deformation behavior, microstructure evolution and fracture mechanism of Inconel 625 superalloy

Failure analysis of sulphidation-oxidation corrosion of Incoloy 800HT superheater tube

Microstructure and High Temperature Fracture Toughness of NG-TIG Welded Inconel 617B Superalloy

Diffusion Brazing Repair of IN738 Superalloy with Crack-Like Defect: Microstructure and Tensile Properties at High Temperatures

Investigation Of Fracture Toughness Of Heat Affected Zone Of 2.25cr-1mo-0.25v Steel Pressure Equipment

ON THE TIME-DEPENDENT MATERIAL FRACTURE TOUGHNESS AT HIGH TEMPERATURE

Microstructure And Properties Of Welded Joint Of Incoloy800h Alloy By Tungsten Argon Arc Welding

Research on Constitutive Equations and Hot Working Maps of Incoloy028 Alloy Based on Hot Compression Tests

Fracture behavior of high-strength steels at elevated temperatures

In-situ SEM study of temperature-dependent tensile behavior of Inconel 718 superalloy

Microcrack Nucleation and Propagation Investigation of Inconel 740H Alloy under in Situ High Temperature Tensile Test

Failure Analysis of High-Temperature Reformer Tube of Incoloy 800H in Synthetic Ammonia Installation

Investigation of the fatigue damage mechanism of Inconel 617 at elevated temperatures obtained by in situ SEM fatigue tests

Anomalous Increase of Fracture Toughness of TiAl-based Alloys at High Temperature

Study on Anti-hydrogen-attack Performance of Incoloy 800H Alloy

Study of Oxidation Behavior and Tensile Properties of Candidate Superalloys in the Air Ingress Simulation Scenario

Tensile Deformation Behavior of Typical Porous Laminate Structure at Different Temperatures