X-ray Scattering from n-alcohol Monolayers at the Water-hexane Interface
A. M. Tikhonov,M. Li,M. L. Schlossman
2002-01-01
Abstract:X-ray scattering during the previous 15 years has radically changed our view of molecular ordering in organic monolayers at the water-vapor interface. A partial motivation for those studies has been to understand molecular ordering in biological membranes. These bilayer lipid membranes exist at liquid-liquid interfaces and consist of molecules that are slightly soluble in the surrounding aqueous medium. As a result, biomembranes are believed to be disordered, possibly significantly more so than their counterparts at the water-vapor interface. As one approach to understanding the molecular ordering in organic assemblies at the liquid-liquid interface, we recently pioneered the use of xray scattering to study the structure of monolayers at the water-oil interface [1]. Initially, we chose to study fluorinated surfactants at the water-hexane interface partially because of the large electron density contrast. Here, we report studies of n-alcohol monolayers at the water-hexane interface. Although this system has much smaller x-ray contrast, it contains surfactants much closer in composition to biological lipids. Samples are prepared by placing a bulk solution of an n-alcohol in hexane on top of bulk water, (the four alcohols used in this study are CH 3 (CH 2 ) m -1 OH, where m = 20, 22, 24, and 30, referred to as C m OH in this article). We study the interface between these two bulk solutions. Previous thermodynamic measurements have shown that the interface undergoes a transition as a function of temperature [2-4]. This is illustrated in Fig. 1, which shows our measurements of interfacial tension γ as a function of temperature for our four systems and for the pure water-hexane interface. The slope, –dγ /dT, is the surface excess entropy. The sharp change in slope reveals an interfacial transition. We have chosen the bulk concentration of C m OH so that the transition is at a convenient temperature. X-ray reflectivity from these interfaces is measured with the liquid surface spectrometer at NSLS beamline X19C [5] using techniques specific to the liquid-liquid interface described previously [1, 6]. Figure 2 shows the reflectivity normalized to the Fresnel reflectivity (for an ideal interface without structure), R/R F , as a function of the wave vector transfer normal to the interface (Q z = (4π/ λ) sinθ, where θ is the angle of specular reflection and λ =0.825 Å). For each of the four systems studied, Fig. 2 shows the measured and fitted R/R F for two temperatures, one far below and the other far above the transition temperature. The data in Fig. 2 for samples below the transition temperature have an oscillation whose period decreases as the alcohol chain length increases. This indicates that the thickness of the alcohol monolayer increases with chain length, as expected. The lines in Fig. 2 that fit these oscillations are derived from a standard fitting procedure using the Born approximation along with a model for the interfacial profile that consists of 2 or 3 layers sandwiched between bulk water and hexane [7]. The interface between each of these layers and an adjacent layer (or bulk) is roughened by capillary waves with a roughness value calculated from the measured interfacial tensions in Fig. 1. The fitting parameters consist only of the electron density of each layer and the layer’s thickness. One expects that an ordered monolayer will be described by a two layer model: the layer next to bulk water would represent the electron density at the position of the head group (COH), the adjacent layer (next to the bulk hexane) would represent the electron den-