Abstract:A model for the onset of the reduction in SRF cavity quality factor, the so-called Q-drop, at high accelerating electric fields is presented. Breakdown of the surface barrier against magnetic flux penetration at the cavity equator is considered to be the critical event that determines the onset of Q-drop. The worst case of triangular grooves with low field of first flux penetration Hp, as analyzed previously by Buzdin and Daumens, [1998 Physica C 294: 257], was adapted. This approach incorporates both the geometry of the groove and local contamination via the Ginzburg-Landau parameter kappa, so the proposed model allows new comparisons of one effect in relation to the other. The model predicts equivalent reduction of Hp when either roughness or contamination were varied alone, so smooth but dirty surfaces limit cavity performance about as much as rough but clean surfaces do. When in combination, contamination exacerbates the negative effects of roughness and vice-versa. To test the model with actual data, coupons were prepared by buffered chemical polishing and electropolishing, and stylus profilometry was used to obtain distributions of angles. From these data, curves for surface resistance generated by simple flux flow as a function of magnetic field were generated by integrating over the distribution of angles for reasonable values of kappa. This showed that combined effects of roughness and contamination indeed reduce the Q-drop onset field by ~30%, and that that contamination contributes to Q-drop as much as roughness. The latter point may be overlooked by SRF cavity research, since access to the cavity interior by spectroscopy tools is very difficult, whereas optical images have become commonplace. The model was extended to fit cavity test data, which indicated that reduction of the superconducting gap by contaminants may also play a role in Q-drop.

The Interactions of Surface Damage on RF Cavity Operation

Investigation Of Breakdown Induced Surface Damage On 805 Mhz Pillbox Cavity Interior Surfaces

rf breakdown with external magnetic fields in 201 and 805 MHz cavities

High-Q operation of SRF cavities: The potential impact of thermocurrents on the RF surface resistance

rf Breakdown with and without External Magnetic Fields

Multi-mode Analysis of Surface Losses in a Superconducting Microwave Resonator in High Magnetic Fields

HIGH POWER RF TEST OF AN 805 MHZ RF CAVITY FOR A MUON COOLING CHANNEL

Draft of PRSTAB paper ELECTRICAL BREAKDOWN OF METALLIC SURFACES

Improving Interface Physics Understanding in High-Frequency Cryogenic Normal Conducting Cavities

Investigations of surface quality and SRF cavity performance

Thermocurrents and their Role in high Q Cavity Performance

Model for initiation of quality factor degradation at high accelerating fields in superconducting radio-frequency cavities

Rf Optimization and Analysis of the 805-Mhz Cavity for the Mucool Program Using Ace3p

The anomalous skin effect and copper cavity operation at cryogenic conditions

THE MUCOOL RF PROGRAM

Coaxial multi-mode cavities for fundamental SRF research in an unprecedented parameter space

Tuning microwave losses in superconducting resonators

Contribution to mid-field Q slope in Niobium SRF cavities from linear RF loss mechanism due to topographic surface structures

Discussion Session Joint with WG4: Updates on the Front End Specification (if Any) and Endorsement: RF Cavity Breakdown in External Magnetic Field

805 MHz and 201 MHz RF Cavity Development for MUCOOL

Prior-damage Dynamics in a High-Finesse Optical Enhancement Cavity