Abstract:The entire process of atomization of the fuel in an internal combustion engine plays a very important role in determining the overall efficiency of these engines. A good atomization process could help the fuel to mix with the air properly leading to its efficient combustion, thereby reducing the emitted pollutants as well. The recent trend followed by the engineers focused on designing fuel injectors for more efficient atomization is to increase the atomization pressure while decreasing the nozzle orifice diameter. A consequence of this is the development of cavitation (formation of vapor cavities or bubbles in the liquid) inside the injector close to the nozzle. The main reason behind this is the sudden changes in the pressure inside the injector and these cavities or bubbles are usually formed where the pressure is relatively low.This work mainly focuses on studying the formation of cavitation and its effect on the velocity of the spray in the near nozzle region using asymmetrical transparent nozzle equipped with a needle lift sensor with nozzle diameter of 0.35 mm at 300 bar of injection pressure. The experiment consists in recording of several image-pairs, which are separated by about 300 ns, capturing the dynamics of the spray, a few millimeters from the nozzle in the direction of the flow. These image-pairs are then used to compute the velocity from the displacement of the liquid structures and ligaments by correlating the first image with the second. About 200 of such velocity graphs are then averaged to obtain a velocity map and is compared with the similar average velocity maps obtained at different times from the start of the injection. The angular spread of the spray from each of these images is calculated as well. The images showing cavitation inside the injector are also recorded at these same instants of time so as to understand the effects of cavitation on the velocity and angular spread of the spray close to the nozzle.

Visualization Research on the Cavitation Phenomena in the Nozzle of Diesel Engine during the Process of Spray by Neutron Radiography

Research on Visulization of Cavitation in Spraying of Diesel Engine

Simultaneous high-speed internal and external flow measurements for a high-pressure diesel nozzle

Visualization analysis of relationship between vortex flow and cavitation behavior in diesel nozzle

Numerical Study of the Impact on High-Pressure and Evaporating Spray Behavior of Nozzle Cavitation at Typical Diesel Engine Conditions

Study of Spray Characteristics Based on a Line X-Ray Phase Contrast Imaging Technique

Effect of Cavitation inside the Diesel Nozzle on the Spray Characteristics

Research Progress of the Measurements of Diesel Spray Characteristics

Quantitative near-field water–air spray measurements at elevated pressures by neutron radiography imaging

Quantification of cavitating flows with neutron imaging

The Research on High-Speed Gas Jet of Rocket Nozzle Underwater

The study of near field in diesel spray based on ballistic imaging

Effect of cavitation on velocity in the near-field of a diesel nozzle

Visualization of internal structure of fuel spray using laser computed tomography technique (2). Applied to diesel spray

Measurement of Nozzle Geometry with X-Ray Phase Contrast Imaging Technique

Research on Nozzle Geometry Measurement with Synchrotron Radiation X-Ray Phase Contrast Imaging Technique

Research Progress for Influence of Nozzle Geometry on Spray Beam and Diesel Engine Performance

Experimental study on influence of pressure fluctuation and cavitation characteristics of nozzle internal flow on near field spray

INVESTIGATION OF THE EFFECTS OF VORTEX-INDUCED STRING CAVITATION ON FLOW AND SPRAY CHARACTERISTICS WITHIN DIESEL FUEL INJECTION NOZZLES

Numerical Study on Internal Nozzle Flow Characteristic of Injector under Hot Fuel Conditions

Shock Wave Research in Diesel Jet