Abstract:Due to moisture in the ore, auxiliary material, and ladle refractory material, the hydrogen element is easily enriched in molten steel. In the metallurgy process, some hydrogen atoms form bubbles and are removed by gravity, whearas others solidify in the strand and remain in the produced steel. When the hydrogen content reaches a certain critical value, the enriched hydrogen atoms congregate to produce a white spot, which greatly reduces the strength and toughness of the steel product, and leads to brittle fracture during its service period. At present, the RH (Ruhrstahl–Heraeus) and VD (vacuum degasser) refining processes are commonly applied in steel plants, which can reduce the hydrogen content to less than 2×10−6. With the demand for high quality steel, the hydrogen content must be further decreased, so hydrogen diffusion in solid steel during the annealing process is gradually attracting increasing attention. In this study, a two-dimensional model was built to investigate the characteristic of dehydrogenation in the bloom annealing process of rail steel. Moreover, the effect of annealing temperature and annealing time on hydrogen diffusion were analyzed, and the annealing parameters were optimized. During the dehydrogenation annealing process, the hydrogen content at the corners and edges of the bloom are found to decrease rapidly, while that in the center of the strand begin to decrease in the later heating stage. As the annealing temperature increases, the starting point of dehydrogenation in the bloom center moves ahead and the maximum dehydrogenation rate increases significantly. With the extension of the soaking period, the central hydrogen content of bloom decreases significantly, but the increase rate of the dehydrogenation gradually decreases. By optimizing the bloom annealing parameters, the hydrogen content in the bloom can be steadily reduced to 0.6×10−6, which fully meets the requirement of high quality steel production.

Study and Application of Dynamic Secondary Cooling on 240 mm×280 mm Rectangular Bloom

Numerical Simulation of Dehydrogenation Annealing in Bloom

Temperature Distribution and Dynamic Control of Secondary Cooling in Slab Continuous Casting

Numerical Simulation of Solidification and Heat Transfer in Continuously Cast Bloom

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Online Dynamic Control of Secondary Cooling for the Continuous Casting Process

Emulation of Dynamic Secondary Cooling and Soft Reduction in Continuous Slab Casting

Research on dynamic secondary cooling control model for slab continuous casting machine with high casting speed

Optimization for Secondary Cooling Parameters in Continuous Casting of High Carbon Chromium Bearing Steel

Dynamic Secondary Cooling of Continiuous Slab Casting by Incremental PID Control

Homogenization Path Based on 250 mm × 280 mm Bloom under Mixed Light and Heavy Presses: Simulation and Industrial Studies

Application of Process Simulation Software on Secondary Cooling Optimization for Continuous Caster

Laboratory Experimental Setup And Research On Heat Transfer Characteristics During Secondary Cooling In Continuous Casting

Investigation of Solidification, Heat Transfer and Fluid Flow in Continuous Casting of Steel Using an Advanced Modeling Approach

Numerical simulation of shrinkage porosity defect in billet continuous casting

Analysis of Internal Cracks in High Carbon Casting Bloom Induced by Soft Reduction Process and Its Improvement Using Numerical Simulations and Industrial Experiments

Modelling of continuous casting processes parameters on the shrinkage cavity formation in bearing steel blooms

Investigation on Heat Transfer in Molds with Different Water-Cooling Structures Under Billet High-Speed Continuous Casting

3D Transient Heat Transfer Simulation and Optimization for Initial Stage of Steel Continuous Casting Process

A Three Dimensional Real-time Heat Transfer Model for Continuous Casting Blooms

Thermomechanical Model of Heat Transffer in Bloom Casting Mold