Abstract:The purpose of this study is to investigate the influence of Cu on TiO2 phase transformation and regioselectivity. TiO2 samples doped with different amounts of Cu2+ ions were synthesized by the sol-gel method. The phase and vibrational mode were characterized by X-ray diffraction (XRD), Fourier infrared spectroscopy (FTIR), and transmission electron microscope (TEM). The XRD phase analysis shows that the lattice parameters have not changed after Cu incorporation. In addition, the content of rutile increased obviously after Cu doping. This indicated that the addition of Cu obviously promoted the transformation from anatase phase to rutile phase. The vibration frequencies were calculated based on the principle of electronegativity. All types of bonds were qualitatively and quantitatively analyzed. The content of TiA-O, TiR-O, and H-O in the undoped TiO2 samples is 23.87%, 16.30%, and 7.41%, respectively. In the same way, the content of TiA-O, TiR-O, H-O, Cu A i -O, and Cu R i -O in the 2.5 mol%Cu-doped TiO2 samples is 21.23%, 18.56%, 7.34%, and 0.98%, respectively. For the 5 mol%Cu-doped TiO2 samples, the content of TiA-O, TiR-O, H-O, Cu A i -O, Cu R i -O, Cu A s -O, and Cu R s -O is 18.75%, 20.11%, 7.47%, 2.56%, 3.9%, 1.55%, and 2.35%, respectively. Cu was not present at substitutional sites in the 2.5 mol% doped sample, but Cu was present in the 2.5 mol% doped sample. It is indicated that Cu was more likely to exist in the form of interstitial position in the TiO2 lattice, with the number of Cu atoms in the interstitial position reaching saturation, and this forced Cu to replace Ti. The TEM shows that the stripes of different periods and orientations overlapped each other to form the Moiré patterns. In addition, the diffraction patterns of the Moiré image were slightly different from that of the matrix. The Cu replaced Ti position and the Cu atoms mixed into interstitial sites in the TiO2 lattice. The theoretical calculation was consistent with the experimental results.

Assignment of Raman-Active Vibrational Modes of Mgtio3

Far Infrared Reflection Spectrum and IR-active Modes of MgTiO3

First-principle calculation and assignment for vibrational spectra of Ba (Mg 1/2 W 1/2) O 3 microwave dielectric ceramic

Assignment for Vibrational Spectra of BaTiO3 Ferroelectric Ceramic Based on the First-Principles Calculation

Study of Raman Spectra for Γ-Al2o3 Models by Using First-Principles Method

Raman Spectra Analysis for Ca(B1/3′B2/3″)O3-based Complex Perovskite Ceramics

First-Principle Calculation And Assignment For Vibrational Spectra Of Ba(Mg1/3nb2/3)O-3 Microwave Dielectric Ceramic

Raman and Dielectric Spectra of Cacu3ti3.9o12 Ceramics

First-principle calculation and far infrared measurement for infrared-active modes of Ba(Mg1/3Ta2/3)O3

Raman-spectroscopy study of PbTiO3 thin films grown on Si substrates by metalorganic chemical vapor deposition

Structure, Intrinsic properties and Vibrational Spectra of Pr(Mg1/2Sn1/2)O3 Ceramic Crystal

Magnetic interactions and the puzzling absence of any Raman mode in EuTiO3

Electronic and vibrational properties of MgCu2O3

Structure, Intrinsic properties and Vibrational Spectra of Pr(Mg 1/2 Sn 1/2 )O 3 Ceramic Crystal

Assignment of Photoelectron Spectra of (tio2)(n) with N=1-3

Optical Properties of Trirutile Structure MgTa2O6 Single Crystals Grown by Optical Floating Zone Method

Vibrational properties of TiVC-based Mxenes by first-principles calculation and experiments

Composition-dependent Optical, Dielectric and D-Orbital Electron Characteristic of High-Throughput Horizontal Composition Gradient Li1-xMgxTi2O4 Combinatorial Film

The Vibrational Spectroscopy of the Valence Bonds of Cu-Doped TiO2 Using Electronegativity Principle Quantitative Calculations

DFT Calculations of Vibrational Spectra and Nonlinear Optical Properties for MgO Nanotube Clusters

Room-Temperature Ferromagnetism and Optical Properties in Mg-Doped Tio2: A Density Functional Theory Investigation