Abstract:Spout-fluid beds are widely used in the process industry due to their facilitation of an efficient contact between particles and gas. In this paper, a two-fluid model (TFM) is set up to reproduce the various flow structures encountered during spout-fluid bed operation. The effects of normal restitution model and gas-solid drag model are assessed by comparing simulation results with the experimental and discrete particle modeling (DPM) data of Link et al. [Link et al. Chem. Eng. Sci. 2005, 60, 3425-3442; Link et al. AIChE J. 2008, 54, 1189-1202.]. Simulation results show that application of an effective restitution coefficient in TFM can improve the accuracy of prediction significantly. The drag model of HKL predicts a more reasonable result than models of Huilin-Gidaspow, BVK, and Syamlal and O'Brien. Analysis on relative contributions of kinetic motion, friction, and collision to particle-particle momentum transfer parameters, namely, particle pressure and viscosity, shows that particle-particle momentum transfer in the spout and fountain regions is dominated by kinetic motion and that in the annulus region is dominated by friction. A transition region between spout and annulus regions is proposed. This region can be delineated using a single parameter of dimensionless collisional particle pressure because in this region, particle pressure is dominated by the collisional contribution. With an increasing spout-fluid ratio, the stable spout-annulus-fountain structure gradually shifts to an unstable bubble-slug structure. The effect of collision increases and extends to the entire bed. Meanwhile, the effects of kinetic motion and friction decrease. When slugs are formed, a rebound in the influence of friction is observed, accompanied by a decrease in the influence of collision.

Correlations for Dynamic Liquid Holdup under Pulsing Flow in A Trickle-Bed Reactor

Gas Holdup and Liquid Velocity Distribution in a Jet Loop Reactor

Flow Regime Transition and Liquid Distribution in a 3D Concurrent Downflow Three-Phase Moving Bed

Gas Holdup and Liquid Velocity Distributions in the Up Flow Jet-Loop Reactor

Studies on hydrodynamics of slurry turbulent bubble column(Ⅰ) Gas holdup and its radial distribution

EXPERIMENTAL INVESTIGATION OF DYNAMIC LIQUID HOLDUP UNDER PULSE FLOW IN TRICKLE-BED REACTOR

A Hydrodynamic Model for Predicting the Characteristic Properties under Pulsing Flow in a Trickle Bed Reactor

On flow regime transition in trickle bed: Development of a novel deep‐learning‐assisted image analysis method

Hydrodynamic behavior of a trickle bed reactor under “forced” pulsing flow

New Correlation for Entrainment Fraction at Onset of Annular Flow

HYDRODYNAMIC CHARACTERISTIC PROPERTIESUNDER PULSING FLOW REGIME

Pressure Drop and Liquid Holdup in Trickle Bed

Liquid Distribution Morphology and Hysteresis Characteristics in Trickle-Bed Reactor

Liquid holdup of gas–liquid two‐phase flow in micro‐packed beds reactors

Hydrodynamics of multiphase flow in a trickle-bed filled with small particles under the supercritical condition

Necessary Condition for Pulsing Flow Inception in a Trickle Bed

Hydrodynamic Modeling on the External Liquid–solid Wetting Efficiency in a Trickling Flow Reactor

Investigation of countercurrent flow profile and liquid holdup in random packed column with local CFD data

Effects of Stagnant Zone on the Effectiveness Factor in a Trickle Bed

New Insights into Transient Behaviors of Local Liquid-Holdup in Periodically Operated Trickle-Bed Reactors Using Electrical Capacitance Tomography (ECT)

Two-Fluid Simulation of a Three-Dimensional Spout-Fluid Bed: Flow Structures, Regimes, and Insight into the Mechanism of Particle–Particle Momentum Transfer