Abstract:Many theoretical and experimental studies have been conducted over the years on liquid entrainment through a branch pipe connected to the main horizontal pipe (i.e., entrainment at the T-junction). Several mathematical models have been developed to predict the onset of liquid entrainment and branch quality during the liquid entrainment process with reasonable accuracy. Most of these models are developed based on small-scale branch, where the ratio of the branch diameter to the horizontal pipe diameter is less than or equal to 0.2 (d/D <= 0.2). Therefore, these models are not suitable to predict the onset of liquid entrainment through a large-scale branch. In addition, these models are developed for a specific branch angle (typically 0 or 90 degrees) and therefore, are incapable of making good predictions of the onset of liquid entrainment through a large-scale branch inclined at other angles. In order to address these issues, we conducted experiments to investigate the onset of liquid entrainment through a large-scale branch pipe (d/D > 0.6) inclined at three angles (32.2, 47.9, and 62.3 degrees) and we assessed the mass flow quality of the branch. By analyzing the mathematical models for liquid entrainment currently available and by theoretical deduction, we developed new correlations to predict the onset of liquid entrainment and mass flow quality. We found that the values predicted by these correlations fit well with the experimental data with a maximum error of +/- 35%. Both of these liquid entrainment correlations provide good predictions of liquid entrainment through a large-scale branch inclined at an angle of 32.2, 47.9, and 62.3 degrees. We also obtained some meaningful conclusions based on the experimental data. We found that at the onset of liquid entrainment, under similar experimental conditions, the critical Froude number Fr, decreases with an increase in the branch angle. In addition, the larger the branch angle, the lower the effect of the branch scale on the onset of liquid entrainment. There are two primary factors that influence the liquid entrainment process: (1) gas chamber height-the liquid entrainment process is promoted as the gas chamber height decreases, and (2) vertical component of the inertial force-the liquid entrainment process is weakened with a decrease in the vertical component of the inertial force. This indicates that the gas chamber height dominates the liquid entrainment process at relatively large branch angles whereas the vertical component of the inertial force dominates the liquid entrainment process at small branch angles.

New Correlation for Entrainment Fraction at Onset of Annular Flow

An Empirical Correlation for the Entrainment Fraction at the Onset of Annular Flow Based on 2006 Chf Look-Up Table

Generalization of Droplet Entrainment Rate Correlation for Annular Flow Considering Disturbance Wave Properties

New Models Of Droplet Deposition And Entrainment For Prediction Of Dryout In Uniform And Non-Uniform Heated Annuli

New Models of Droplet Deposition and Entrainment for Prediction of Liquid Film Flow in Vertical Annuli

An Assessment of Void Fraction Predicting Methods for Gas-Liquid Two-Phase Flow in an Annulus

Liquid droplet entrainment in an annular flow boiling regime—A Bayesian regularization algorithm based study

Experimental and modeling study on liquid film thickness of horizontal gas-liquid annular flow using ultrasonic method

An optimize empirical correlations for liquid film thickness and interfacial friction factor in vertical gas-liquid annular flow

PREDICTION MODEL OF ANNULAR FLOW HEAT TRANSFER COEFFICIENT WHEN CONSIDER LIQUID DROP ENTRAINMENT

Circumferential incoherent distribution of film thickness for multi-dimensional two-phase annular flow

Numerical Investigation on the Dryout Point of Annular Flow in the Upward Narrow Annuli with Bilateral Heating

Probability model for gas–liquid annular flow in dynamic equilibrium among the processes of atomization, deposition, breakup, and coalescence

Phenomenological Modelling of Chf in Annular Flow in Annuli Using New Models of Droplet Deposition and Entrainment

Interfacial wave velocity of vertical gas-liquid annular flow at different system pressures

Development of Correlations for Liquid Entrainment Through a Large-Scale Inclined Branch Pipe Connected to the Main Horizontal Pipe

Theoretical Calculation Of The Critical Heat Flux In Annular Upward Flow In Vertical Narrow Rectangular Channels

Development of a Three-Field Mechanistic Model for Dryout Prediction in Annular Flow

Analysis of the Interchange Rate and Pressure Gradient of Annular Flow Based on a Probability Model

Heat transfer correlation of smooth inverted annular film boiling in a circular tube

Experiment and Modeling of Interfacial Area Concentration of Liquid Film in Upward Annular Two-Phase Flow