Abstract:This study aims to investigate the effect of tundish level control on the change in element content and inclusion amount in molten steel during the low tundish-level steel grade transition. Based on multiphase flow, mass transfer, and discrete phase, a three-dimensional transient numerical simulation of the tundish was established in Ansys Fluent. The model uses moving mesh refinement technology to obtain clear steel and slag interface with a small number of meshes. The numerical simulation results were verified through industrial experiments and physical simulations. The results indicate that when the tundish is at a low level, strand 3 becomes a short-circuit flow, and the number of inclusions in strand 3 is approximately four times that in strand 1. If the old grade density is higher than that of the new grade, the unqualified length of the element content in the transition billet is 10.2 m shorter than that in the opposite order. When the filling speed of the tundish is three times the normal flow rate, the length of the transition billet with an unqualified number of inclusions is 7.1 m less than that when the filling speed is 2 times the normal flow rate. In addition, at the initial stage of the low tundish level steel grade transition, the minimum amount of inclusions in the transition billet can be reduced to 40% of the average amount of inclusions in the old grade; however, the maximum number of inclusions in the transition billet increase by a factor of 2.5 times the average number of inclusions in the new grade at the end stage of the low tundish-level steel grade transition. It can be observed that the inclusions in the initial stage of the low tundish-level steel grade transition have less effect on the quality of the old grades; however, they have a greater effect on the new grades in the final stage of the low tundish-level steel grade transition.

Mathematical modeling of fluid flow, heat transfer and inclusion transport in a four strand tundish

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Simulation of Fluid Flow and Inclusion Removal in Five-Flow T-Type Tundishes with Porous Baffle Walls

Design Improvement of Four-Strand Continuous-Casting Tundish Using Physical and Numerical Simulation

ESTABLISHMENT OF A FULL SCALE TUNDISH PHYSICAL SIMULATION PLATFORM AND APPLICATION RESEARCH

Numerical modeling of grade mixing and inclusion entrapment in eight strand billet tundish

Numerical Simulation for the Improved 6 Strand Bloom Tundish of Baotou Steel

Hydraulic and Numerical Simulation of Flow Field Characteristics in Induction Heating Continuous Casting Tundish

Water model study on the new designed tundish in Xingcheng special steel

Numerical Investigation on Transient Flow and Inclusion Removal Behavior in Tundish During Ladle Change Process

Study of Flow Characteristics of Tundish Based on Digital Image Velocimetry Technique

The Removal of Inclusions with Different Diameters in Tundish by Channel Induction Heating: A Numerical Simulation Study

Molten Steel Flow, Heat Transfer and Inclusion Distribution in a Single-Strand Continuous Casting Tundish with Induction Heating

Numerical Investigation on Motion and Removal of Inclusions in Continuous Casting Tundish with Multiorifice Filter

Application of Modeling and Simulation of Thermal Stress in Solidification Process of a Heavy Steel Casting

Simulation Study on the Influence of Different Molten Steel Temperatures on Inclusion Distribution under Dual-Channel Induction-Heating Conditions

Numerical Simulation of Convection and Inclusion Distribution During Solidification in a Heavy Steel Ingot

Numerical simulation on flow and heat transfer in twin roll strip casting and rolling molten pool with side dams vibrating

Numerical Simulation of Steel Flow Through a One Strand Slab Tundish with Steel Flow Control Devices

Numerical Simulation on Multiple Physical Fields Behaviors in Billet Continuous Casting with Different Stirrer Positions

Flow Characteristics for Two-Strand Tundish in Continuous Slab Casting Using PIV