Abstract:A detailed knowledge of structural evolution during mechanical alloying (MA) is of interest and critical for understanding of synthesis mechanism, optimization of milling process, and control of milling products. The structural evolution of the 2Si-BN-3C mixture with a molar ratio of Si:BN:C = 2:1:3 during MA was studied by investigating the changes of phases, morphologies, elemental distributions, microstructures, and chemical bond states using XRD, SEM-EDS, TEM, XPS, and Raman. With the increases in milling time, the particle sizes of the milled 2Si-BN-3C powders first decrease to submicrometers (similar to 1 hour), slightly increase afterward (similar to 3 hours), and eventually decrease to nanoscales gradually reaching equilibrium (>= 10 hours). Depending on the intrinsic crystal structures of themselves, h-BN and graphite are almost amorphized after milling of 10 hours, while amorphization of c-Si takes at least 20 hours. The same milling parameters can provide amorphous Si2BC3N powders, but incompletely amorphous (partially crystalline) SiC powders, which is mainly due to the dilution effect of B and N atoms on the atomic concentration of Si and C hindering the microdiffusion and subsequent mechanochemical reaction of Si and C. Crystallite refinement-induced amorphization is the major synthesis mechanism of amorphous Si2BC3N powders. This work would offer more insight into the MA synthesis of multiple component materials, especially Si-based brittle systems.

Preparation and characterization of CBN ternary compounds with nano-structure

Study on the Bonding State for Carbon–boron Nitrogen with Different Ball Milling Time

Influence of ball milling parameters on the structure of the mechanically alloyed SiBCN powder

Preparation and Microstructure of the B4C/BN Nanocomposite Powders

Preparation of Nb3al by High-Energy Ball Milling and Superconductivity

Fabrication and characterization of amorphous SiBCN powders

Microstructural Features and Properties of the Nano-Crystalline SiC/BN(C) Composite Ceramic Prepared from the Mechanically Alloyed SiBCN Powder

Formation of Nanocrystalline Fcc Phase by Mechanically Driven Crystallization

Carbon content-dependent microstructures, surface characteristics and thermal stability of mechanical alloying derived SiBCN powders

Microstructure evolution of Ti/BN powder blend during ball milling and heat treatment

Preparation of Cbnp/Nicral Nanostructured Composite Powders by A Step-Fashion Mechanical Alloying Process

Formation Of Tib2/Tin/Ti (Cxn1-X) Nanocomposite Powder Via High-Energy Ball Milling And Subsequent Heat Treatment

Microstructure and tribological properties of ternary BCN thin films with different carbon contents

Fabrication Of Tbcu7-Type Single Phase Sm-Fe-Zr-Nb Alloys By Melt-Spinning Combined With High-Energy Ball Milling

Synthesis Mechanism of Amorphous Si2BC3N Powders: Structural Evolution of 2si‐bn‐3c Mixtures During Mechanical Alloying

Boron‐dependent Microstructural Evolution, Thermal Stability, and Crystallization of Mechanical Alloying Derived SiBCN

Effects Of Mechanical Ball Milling Time On The Microstructure And Mechanical Properties Of Mo2nib2-Ni Cermets

Ta(B, C, N) and (ta, Mi)(B, C, N) (mi = Nb, W) Ceramics by High‐energy Ball Milling: Processing and Solution Mechanisms

Carbon‐content‐dependent Phase Composition, Microstructural Evolution, and Mechanical Properties of SiBCN Monoliths

Microstructure and Thermal Stability of Amorphous SiBCNAl Powders Fabricated by Mechanical Alloying

TiN graphene crystals on the surface of CBN by microwave-salt molten treatment