Preparation and characterization of thermo-responsive PDMS surfaces grafted with poly(N-isopropylacrylamide) by benzophenone-initiated photopolymerization.

Dan Ma,Hengwu Chen,Dongyan Shi,Zhiming Li,Jinfu Wang

DOI: https://doi.org/10.1016/j.jcis.2008.12.046

IF: 9.9

2009-01-01

Journal of Colloid and Interface Science

Abstract:In the preparation of a thermo-responsive, poly(N-isopropylacrylamide) (PNIPAAm)-grafted polydimethylsiloxane (PDMS) surface by means of benzophenone-initiated photopolymerization, we observed that thick (>1 mm) PDMS substrates were much more difficult to be grafted with PNIPAAm than thin ones. Investigations revealed that the shortage of diffused benzophenone molecules in the surface region of the thick substrate might be the reason. By prolonging the time spent for treating the substrate with a benzophenone solution, PNIPAAm could be successfully grafted onto thick PDMS substrates. The PNIPAAm-grafted PDMS surface was highly thermo-responsive. The contact angle on a grafted surface increased from 38 to 91° in response to the temperature increase from 20 to 38 °C. An electroosmotic flow (EOF) mobility of 5×10−4 cm2/Vs was supported by a PNIPAAm-grafted PDMS channel at 50 °C, whereas negligible EOF was observed at 20 °C. Doxorubicin (DX), an anticancer drug, was adsorbed by the grafted surface at 40 °C, and the majority of the adsorbed DX was quickly released from the surface to a stripping solution at 5 °C. Osteoblast cells adhered onto the PNIPAAm-grafted PDMS surface and proliferated therein at 37 °C, while the cell sheet detached from the surface by lowering the temperature to 25 °C without using any enzymatic agent.