Abstract:Metallic glasses, with their short-range order structure, exhibit unique characteristics that do not exist in the corresponding crystalline alloys with the same compositions. These unusual properties are attributed to the absence of translational periodicity, grain boundaries, and compositional homogeneity. Cobalt (Co)-based metallic glassy alloys have been receiving great attention due to their superior mechanical and magnetic properties. Unluckily, Co-Ti alloys and its based alloys are difficult to be prepared in glassy form, due to their rather poor glass-forming ability. In the present work, the mechanical alloying approach was employed to investigate the possibility of preparing homogeneous (Co75Ti25)100-xBx starting from elemental powders. The feedstock materials with the desired compositions were high-energy ball-milled under argon atmosphere for 50 h. The end products of the powders obtained after milling revealed a short-range order structure with a broad amorphization range (2 at% ≤ B ≤ 25 at%). The behaviors of these glassy systems, characterized by the supercooled liquid region, and reduced glass transition temperature, were improved upon increasing B molar fraction. The results had shown that when B content increased, the saturation magnetization was increased, where coercivity was decreased.

Glass Formation in a Ni-Based Multicomponent Alloy by Mechanical Milling and Microwave Treatment of the Obtained Powders

Glass Formation in Mechanical Milled Ni-Ti-Zr-Sn Pre-Alloy Powders

Fabrication of Ni-Nb-Sn metallic glassy alloy powder and its microwave-induced sintering behavior.

Formation and Mechanical Properties of Bulk Glassy Ni57-Xti23zr15si5pdx Alloys

Effect of Sn on microwave-induced heating and sintering of Ni-based metallic glassy alloy powders

Glass-forming Ability and Crystallization Behavior of Some Binary and Ternary Ni-based Glassy Alloys

Microwave Sintering of Ni-Based Bulk Metallic Glass Matrix Composite in a Single-Mode Applicator

Formation of Zr70Ni23Ti7 Glassy Alloy and Phase Transformation Upon Annealing

Microstructural Changes during Microwave Heating of Ni<SUB>52.5</SUB>Zr<SUB>15</SUB>Nb<SUB>10</SUB>Ti<SUB>15</SUB>Pt<SUB>7.5</SUB> Metal Glasses

Microstructural Changes During Microwave Heating of Ni52.5zr15nb10ti15pt7.5 Metal Glasses

Nanocrystallization of Fe73si7b17nb3 Metallic Glass Induced by Microwave Treatment in Magnetic Field of A Single Mode 915 Mhz Applicator

Ni-Nb-Sn Bulk Metallic Glass Matrix Composites Fabricated by Microwave-Induced Sintering Process

Formation, Thermal Stability and Mechanical Properties of Zr-Nb-Cu-Ni-Al Bulk Metallic Glasses

Metastable Nanocrystallization Behavior of Ti-based Metallic Glassy Powders During Post-Heating

Glass-Forming Ability and Thermal Properties of Al70Fe12.5V12.5X5(X = Zr, Nb, Ni) Amorphous Alloys via Minor Alloying Additions

Formation and mechanical properties of bulk Cu-Ti-Zr-Ni metallic glasses with high glass forming ability

Glass Forming Ability and Mechanical Properties of New Ni-Based Bulk Metallic Glasses

Microstructures of Microwave Heated Soda-Lime Glass - Fe Composite and Ni-Zr-Nb-Ti-Pt Metallic Glass

Mechanically-Induced Solid-State Reaction for Fabrication of Soft Magnetic (Co75Ti25)100-xBx (x: 2, 5, 10, 15, 20, 25 at%) Metallic Glassy Nanopowders

Microwave-Induced Sintering of Ninbtipt Metallic Glass Blended with Sn Powders Using A Single-Mode Applicator

Formation and Properties of Two-Phase Bulk Metallic Glasses by Spark Plasma Sintering