Abstract:Tungsten-based scandate dispenser cathodes are promising next-generation thermionic electron sources for vacuum electron devices, due to their excellent emission performance at temperatures lower than those required for conventional cathodes. There has been a significant recent effort to understand scandate cathode performance and to characterize the tungsten and other materials on the emitting surface, primarily via the study of cathodes before and after emission testing. Moreover, these scandate cathodes have typically been characterized at room temperature only. In situ observations of scandate cathodes is challenging, as these devices are thermionic emitters that operate in a high-vacuum environment, and because the sizes of relevant material features range from the micron (2.0 μm) to the nanometer (<50 nm diameter) length scales. In the current study, a series of in situ heating experiments was conducted on un-activated impregnated scandate cathode fragments, utilizing a micro-electro-mechanical system-based heater chip in a scanning electron microscope, enabling the real-time observation of cathode material evolution at elevated temperature (up to 1200 °C) under a pressure of 10−6 to 10−7 mbar. This study revealed how impregnant materials grow and migrate within the cathode matrix at elevated temperatures, and these observations are key to a thorough understanding of the behavior of scandate cathode materials. It also enabled direct observation of the incipient faceting of tungsten surfaces at high temperature while surrounded by impregnant materials. These are the first in situ observations of scandate cathode material evolution in relevant environmental conditions and at sufficiently high resolution to provide insights into the morphological and phase changes that occur in the near-surface regions of scandate cathodes.

Electronic Microanalysis of Black Spots on the Cathode Surface Used in Travelling-Wave Tube

Microdischarge Process and Vacuum Ultraviolet Emission Properties of Dielectric-Barrier-Discharge-Type Flat Fluorescent Lamps

P‐129: The Black Spot Phenomenon and Improvement in QLED Devices

Study on microspot splitting characteristics in cathode spot motion of vacuum arc

Study on the sealing-white-line of pin used in the color picture tube

The motion and distribution characteristics of cathode spot and its influence on plasma parameters

Research on the Failure Emitter of Hollow Cathode by FESEM

Degradation Factors Of A New Long Life Cathode

The Mechanism of Pt Films to Suppress the Electron Emission of Grid in TWTs

Failure Analysis on Diode-triggered Silicon-Controlled Rectifiers by Using Nondestructive X-ray Microscopy

The Effect of Thermal and Moisture Stress on Insulation Deterioration Law of Ionic Contaminated High-Voltage Printed Circuit Board of Electronic Power Conditioner

Research and Design of Magnetic Field in Transition Area for Traveling-Wave Tubes

Research on Antimony-Cesium Photocathode Based on Tungsten Substrate

A study on surface-temperature measurement by means of a vacuum-arc cathode under different current conditions

Study on Low-Temperature Emission Performance of Scandate Cathode with Micro-Blade-Type Arrays

Growth and Faceting of Tungsten and Oxides in Scandate Cathode Particles during In Situ Heating in the Scanning Electron Microscope

Study on Emission Properties of the Nanopatical Films

Experimental Analysis of A New Retarding Field Energy Analyzer

Design and Analysis of Electron Beam of 0.67 THz Traveling Wave Tube

Overview of the Semiconductor Photocathode Research in China

Generation and Stable Transmission of Miniature Electron Beams for 0.65-THz Traveling Wave Tubes