Abstract:Natural porous mineral supported (TiO2/diatomite) photocatalyst was prepared via a modified sol–gel method using titanium (IV) butoxide (TBOT) and diatomite. The effect of TBOT dosage on adsorption capacity and photocatalytic activity for Rhodamine B (RhB) solution was investigated. The morphology and elemental distribution were determined by scanning electron microscopy with attached energy-dispersive X-ray detector. The porous and crystalline structures were characterized using nitrogen adsorption–desorption and X-ray diffraction techniques, respectively. The prepared TiO2/diatomite hybrid catalyst has shown relatively even porous structure and dispersion of TiO2 over the surface. This suggests that the diatomite matrix prevented the agglomeration of TiO2 particles. Initially, the surface area and pore volume of the hybrid catalyst were increased by adding TBOT then decreased for dosages higher than 1.0ml. The crystalline size of TiO2 immobilized on diatomite matrix by sol–gel method was around 20nm. When the experiments were carried out in the absence of diatomite, this value was increased to 33.73nm. The use of diatomite also promoted an increase of the transformation temperature of the crystalline phase anatase to rutile for the TiO2. The as-prepared TiO2/diatomite composite exhibited high photocatalytic activity (96.0% for 0.5h UV-light irradiation) for the degradation of RhB from wastewater as a result of its unique porous structure and optimum TiO2 loading. In addition, it can be easily separated from suspension and possess a good durability. This hybrid material holds great promise in the engineering field for the environmental remediation.

Photocatalytic Degradation of Rhodamine B on Anatase, Rutile, and Brookite Tio2

Photocatalytic and photoelectrocatalytic degradation of aqueous Rhodamine B by low-temperature deposited anatase thin films

Photodegradation of Rhodamine B in Water Assisted by Titania Films Prepared Through a Novel Procedure

In-Suit Preparation of Cubic Anatase Tio2 Crystals and Its Photocatalysis Property on Rhodamine B

Photocatalytic Degradation of Rhodamine B on Co-doped TiO_2 Thin Film under Visible Light

Solar photocatalytic degradation of dye wastewater in the presence of heat‐treated anatase TiO<sub>2</sub>powder

Photocatalytic degradation of dyestuff wastewater under visible light irradiation using micron-sized mixed crystal TiO2 powders

Tunable Synthesis of Enhanced Photodegradation Activity of Brookite/Anatase Mixed-Phase Titanium Dioxide

Synthesis of Natural Porous Minerals Supported Tio2 Nanoparticles and Their Photocatalytic Performance Towards Rhodamine B Degradation

Brookite Vs Anatase Tio2 In The Photocatalytic Activity For Organic Degradation In Water

Photodegradation Of Rhodamine B In Water Assisted By Titania Nanorod Thin Films Subjected To Various Thermal Treatments

Synthesis Of Crystal-Controlled Tio2 Nanorods By A Hydrothermal Method: Rutile And Brookite As Highly Active Photocatalysts

The Positive Effect of Anatase and Rutile on the Brookite-Photocatalyzed Degradation of Phenol

Tartaric Acid-Assisted Preparation and Photocatalytic Performance of Titania Nanoparticles with Controllable Phases of Anatase and Brookite

Enhanced activity of bismuth-compounded TiO2 nanoparticles for photocatalytically degrading rhodamine B solution

Low-Temperature Deposition of Anatase Thin Films on Titanium Substrates and Their Abilities to Photodegrade Rhodamine B in Water

Photocatalytic degradation of selected dyes by titania thin films with various nanostructures

Evaluation of photocatalytic activity of pigmentary titania

Investigation on the Sonocatalytic Degradation of Acid Red B in the Presence of Nanometer TiO2 Catalysts and Comparison of Catalytic Activities of Anatase and Rutile TiO2 Powders.

Photo Degradation on Rhodamine B for Anatase TiO_2 Sol under UV,Visible Light and IR

Synthesizing and Comparing the Photocatalytic Properties of High Surface Area Rutile and Anatase Titania Nanoparticles