Abstract:The two-phase isochoric heat capacity ( VT ), liquid–gas phase transition ( , ), vapor-pressure ( , ), and thermal -pressure coefficient of methyl dodecanoate, a key biofuels component, have been measured along nine liquid isochores between (180.90 and 845.31) kg·m −3 and three near-critical liquid and vapor (180.90, 234.52, and 374.11) kg·m −3 isochores. The temperature range covers the liquid–vapor phase transition temperature for each measured isochore to near the thermal decomposition temperature, 450 K. The measurements were performed using a high-temperature and high-pressure, nearly constant-volume adiabatic calorimeter previously used for the measurements of the VT relationship of biofuel components in the two- and single-phase region. The combined expanded uncertainty of the density ( ρ ), temperature ( T ), and isochoric heat capacity ( ) measurements at the 95% confidence level with a coverage factor of k = 2 is estimated to be 0.15%, 15 mK, and 2%, respectively. The isochoric heat capacity discontinuity point was used as the criteria of the liquid–gas phase transition temperature, . For each experimental liquid isochore, most measurements were concentrated in the immediate vicinity of the liquid–gas phase transition temperature ( ) to precisely determine the phase boundary properties ( , , , and ) using an isochoric heat -capacity abrupt-behavior technique. For nine liquid isochores between (745.16 and 845.31) kg·m −3 the phase transition temperatures ( ) were experimentally determined. For two vapor (180.90 and 234.52) kg·m −3 and liquid near-critical (374.11) kg·m −3 isochores, for which the transition temperatures are very high (above the thermal decomposition temperature, 473 K), we failed to reach the phase-transition temperatures, , because for these isochores the thermal decomposition of methyl dodecanoate occurs before reaching the phase transition temperature (above 673 K). The measured two-phase ( ) isochoric heat capacities as a function of specific volume ( V ) along the various isotherms (below 473 K) were used to accurately estimate the values of the second temperature derivatives of chemical potential, , and vapour-pressure, , based on the Yang–Yang theoretical relation. The contributions of the vapour-pressure, , and the chemical potential, , to the heat capacities of the measured total two-phase were estimated as a function of temperature. In addition, measured and phase boundary ( , , ) property data were used to calculate key thermodynamic property data , , , , , , along the saturation curve. The measured vapor-pressure ( − -Abstract Truncated-

Heat capacity and thermodynamic properties of 1-hexadecanol

Molecular Dynamics Simulation on Solidification Process of N-Hexadecane Systems

Measurements of Density and Viscosity of 1-Hexadecanol in the Temperature Range from (328.15 to 623.15) K at Pressures Up to 10 MPa

Low-temperature heat capacities and thermodynamic properties of 2,2-dimethyl-1,3-propanediol

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Contribution of the Hydroxyl Group on Interfacial Heat Conduction of Monohydric Alcohols: A Molecular Dynamics Study

Heat capacity and thermal decomposition of 1,6-bis(diphenylphosphino)hexane

Low-temperature heat capacities and phase transitions of the ternary system of (0.195 ethandiol + 0.132 ethanol + 0.673 water)

Heat Capacity of Liquid Octamethyltrisiloxane (MDM) and Hexamethyldisiloxane (MM): Measurement and Molecular Dynamics Study

Excess Molar Enthalpies of Dimethyl Carbonate and (butanol Isomers and 1-Pentanol) at T = (298.15, 313.15, and 328.15) K and P = (0.1, 1.0, and 10.0) MPa

Heat capacities and thermal conductivity of ternary mixtures of water+ethanol+1,2-ethanediol between 75 and 350 K

Thermodynamic Investigation of Several Natural Polyols (IV): Heat Capacities and Thermodynamic Properties of Adonitol

Density, Viscosity, and Freezing Point for Four Binary Systems of N-Dodecane or Methylcyclohexane Mixed with 1-Heptanol or Cyclohexylmethanol

Excess Molar Enthalpies of Methyl Acetate and (1-Propanol, 2-Propanol, 1-Butanol, 2-Butanol, and 1-Pentanol) at T = (298.15 and 308.15) K and P = (5.0 and 10.0) MPa

Non-isothermal Decomposition Kinetics, Heat Capacity and Thermal Safety of 37.2/44/16/2.2/0.2/0.4-Gap/cl-20/al/n-100/pca/auxiliaries Mixture.

Two-Phase Isochoric Heat Capacity, Phase Transition, and Theoretically Important Physical Parameters of Methyl Dodecanoate

Isobaric Heat Capacities of Exo-Tetrahydrodicyclopentadiene at Temperatures from 323 K to 523 K and Pressures Up to 6 MPa

Liquid-liquid Phase Equilibrium and Heat Capacity of Binary Solution {2-Propanol + 1-Octyl-3-methylimidazolium Hexafluorophosphate}

Thermophysical properties of n-hexadecane: Combined Molecular Dynamics and experimental investigations

Volumetric Properties of N -Hexadecane/ethyl Octanoate Mixtures from 293.15 K to 363.15 K and Pressures Up to 60 MPa

Molar Heat Capacity and Thermodynamic Properties of 1,2-Cyclohexane Dicarboxylic Anhydride [C8H10O3]