Ozone Enhanced Activity of Aqueous Titanium Dioxide Suspensions for Photodegradation of 4-Chloronitrobenzene.

Miaomiao Ye,Zhonglin Chen,Xiaowei Liu,Yue Ben,Jimin Shen
DOI: https://doi.org/10.1016/j.jhazmat.2009.01.091
IF: 13.6
2009-01-01
Journal of Hazardous Materials
Abstract:The TiO2/UV/O3 process has been employed to remove 4-chloronitrobenzene (4-CNB) and compared to UV/air, O3, TiO2/O3, TiO2/UV/O2 and UV/O3 five parallel oxidation pathways. The reaction activities of these six processes were tested in aqueous using electron paramagnetic resonance (EPR) spin trapping technique with 5,5-dimethyl-1-pyrroline N-oxide (DMPO) spin trap. Moreover, the effects of ozone dosage, catalyst dosage and initial solution pH on the degradation of 4-CNB by TiO2/UV/O3 process were also investigated. Results showed that the TiO2/UV/O3 is the most efficient process for complete mineralization of 4-CNB since the combination of photocatalytic oxidation with ozone has a synergistic effect. The relative intensity of DMPO-OH follows the order of UV/air<O3<TiO2/O3<UV/O3<TiO2/UV/O2<TiO2/UV/O3. In TiO2/UV/O3 process, the ozone and catalyst dosage are found to have a significant impact on the process efficiency whereas initial pH has relatively less effect. Chlorine atoms of 4-CNB are absolutely oxidized to chloride anions when the ozone dosage in the range of 5–18mg/min, or the catalyst dosage ranging from 1.0 to 2.0g/L. Part of chloride anions would be further oxidized to chlorate(V) ions if the ozone dosage exceeds 24mg/min, or the catalyst dosage exceeds 2.0g/L.
What problem does this paper attempt to address?