Abstract:Intention, goal, scope, background: Advanced oxidation processes are powerful methods which are capable of transforming refractory, nonbiodegradable and/or toxic organic compounds into harmless end products such as carbon dioxide and water. However, one commen problem of all advanced oxidation processes is the high demand of electrical energy for ultraviolet lamps, which causes high operational costs. Minimization of the required irradiation time, and therefore the energy consumption, by optimization of other reaction conditions such as catalyst-oxidant type and concentration, pH, temperature, pollutant/oxidant ratio etc., therefore continues to gain importance. Objective: The main objective of this study was the minimization of the required irradiation time through optimization of the use of a newly patented catalyst, ferrioxalate, and also to compare the performance of this catalyst with the performance of other AOPs. Methods: Oxidation of 4-chlorophenol by photo-Fenton process using potassium ferrioxalate as a mediator was studied in a lab scale photoreactor. The influence of parameters such as hydrogen peroxide and ferrioxalate concentrations, initial pH, power-output, oxalate/iron ratio and different iron sources was evaluated. An upflow photoreactor equipped with a 1000 Watt high-pressure mercury vapour lamp and operating in a recirculation mode was used during photodegradation experiments. The extent of the reduction of 4-chlorophenol, Total Organic Carbon and Chemical Oxygen Demand was used to evaluate the photodegradation reaction. Results and discussion: The optimum pH range observed was found to be 2.7-3. The efficiency of 4-chlorophenol oxidation increased with increasing concentrations of hydrogen peroxide and ferrioxalate, reaching a plateau after the addition of 10 and 0.072 mM of those reagents, respectively. Using an Oxalate/iron ratio of 12 was 18% less efficient than using a ratio of 3:1. The efficiency increased with increasing radiation power. However, this increase was not linear. The UV/ferrioxalate/H2O2 process, by which complete mineralization of 100 mg l(-1) 4-chlorophenol was achieved in 20 min of total reaction time, was the most efficient process among the alternatives applied. Conclusions: The use of ferrioxalate as the catalyst was found to be more efficient than the use of Fe(II) and Fe(III) iron species. It was possible to completely mineralize 4-chlorophenol. Recommendation and outlook: The results of this study demonstrate that the ferrioxalate-mediated degradation of 4-chlorophenol requires less irradiation times than other advanced oxidation processes. There are mainly 19 phenol isomers and other toxic and nonbiodegradable organic compounds. We recommend that similar studies should be performed on many such compounds in order to attain a clear understanding of the performance of this catalyst. Because of its light sensitivity, this catalyst should be used immediately after its preparation. The use of low pressure mercury vapour lamps in this process should also be considered, since low power outputs may be enough for the process.

Comparative Study of Degradation of 4-Chlorophenol by Ultraviolet Irradiation/sodium Hypochlorite and Ultraviolet Irradiation/ozonation

Chlorophene Degradation by Combined Ultraviolet Irradiation and Ozonation.

Adsorbable Organic Halogens Generation and Reduction During Degradation of Phenol by Uv Radiation/Sodium Hypochlorite

DEGRADATION OF 2,4-DICHLOROPHOXYACETIC ACID BY OZONE WITH ULTRASOUND (Ⅱ)DEGRADATION PATHWAY

DEGRADATION OF 2,4-DICHLOROPHOXYACETIC ACID BY OZONE WITH ULTRASOUND(Ⅰ)SYNERGISTIC EFFECT OF OZONATION AND SONOLYSIS

Ultraviolet Irradiation Combined with Manganese Ore Catalyzed Ozonation of 4-Chlorophenol in Aqueous Solution

The Mechanism and Pathway of the Ozonation of 4-Chlorophenol in Aqueous Solution

Influencing factors and mechanism of decomposition of 4-nitrophenol by US/O3

Degradation of 4-Chlorophenol by High-Voltage Pulse Corona Discharges Combined with Ozone

Degradation Of Aqueous Polycyclic Musk Tonalide By Ultraviolet-Activated Free Chlorine

[Degradation of 4-Chlorophenol in Aqueous Solution by High-Voltage Pulsed Discharge-Ozone Technology].

Comparison of UV/H2O2, UV/PMS, and UV/PDS in Destruction of Different Reactivity Compounds and Formation of Bromate and Chlorate

Degradation of 4-Chlorophenol Solution by Synergetic Effect of Dual-frequency Ultrasound with Fenton Reagent

Ozone Enhanced Activity of Aqueous Titanium Dioxide Suspensions for Photodegradation of 4-Chloronitrobenzene.

Degradation Kinetics of 2,4-Dichlorophenol by Gamma Ray Irradiation in the Presence of Ozone

Kinetic modelling for concentration and toxicity changes during the oxidation of 4-chlorophenol by UV/H2O2

Degradation of Phenol in Water by Microwave-Assisted Chlorine Dioxide Oxidation

Degradation of aqueous phenol by combined ultraviolet and electrochemical oxidation treatment

Ferrioxalate-mediated photodegradation and mineralization of 4-chlorophenol

Advanced oxidations of chloroacetic acids present in drinking water

Photocatalytic degradation of phenols in aqueous solution under irradiation of 254 and 185nm UV light