Abstract:In order to gain insight into the influence of grain size on precipitation thermodynamics, bulk materials of coarse-grained (CG), ultrafine-grained (UFG) (with or without dislocations), and nanocrystalline (NC) 7075 Al alloy have been fabricated by solid solution treatment, equal-channel angular pressing (ECAP), or high-pressure torsion (HPT) processes. The precipitation behavior and the corresponding thermal phenomenon were studied by transmission electron microscopy (TEM) and differential scanning calorimetry (DSC) heating. The results indicated that there are significant differences in precipitation thermodynamics among the four bulk materials. In the CG and UFG materials without dislocations, homogeneous nucleation is the primary precipitation mechanism. However, the nucleation of the GP zones is suppressed at lower temperatures due to a reduction in the number of residual vacancies and the supersaturation in the UFG interiors. This is attributed to the absorption of vacancies and solute atoms by a greater volume of grain boundaries. It can be observed that the greater the excess of vacancies remaining in grain interiors, the lower the temperature at which nucleation of GP zones occurs. Defect-assisted heterogeneous nucleation was identified as the predominant precipitation mechanism in the UFG materials with dislocations and the NC materials. These defects encompass dislocations, lattice distortions, and grain boundaries. The decomposition processes of solid solutions were found to be almost complete at a lower temperature. The presence of dislocations, lattice distortions, and grain boundaries enables solute atoms to diffuse at a much faster rate, significantly enhancing the precipitation rate and reducing the nucleation and formation energies of various precipitate phases.

Initiation of Discontinuous Precipitation at Interphase Boundaries in a Two-Phase Zn–6.3 At.% Ag Alloy

Discontinuous Precipitation Initiated At Interphase Boundaries In A Zn-Rich Zn-6.3 At.% Ag Alloy

Evolution of Precipitate and Precipitate/matrix Interface in Al-Zn-Mg-Cu(-Ag)alloys

Atomic-scale study on the precipitation behavior of an Al-Zn-Mg-Cu alloy during isochronal aging

Phase-Field Modeling of Solute Trapping in Single-Phase Alloys During Directional Solidification

Precipitation Sequence of Middle Al Concentration Alloy Using the Inversion Algorithm and Microscopic Phase Field Model

Interaction Between Coherent Second-Phase Particles and Migrating Boundaries: Boundary Effect and Particle Reorientation

Early Stages of Precipitation in Γ' Phase of a Ni–Al–Ti Model Alloy: Phase-Field and First-Principles Study

The Effect of Discontinuous Γ' Precipitation on the Mechanical Properties of Al-Co-Ni Alloys

Numerical Simulation of Solute Segregation Patterns for a Binary Alloy Using Phase-Field Approach

Atomic-scale study of compositional and structural evolution of early-stage grain boundary precipitation in Al–Cu alloys through phase-field crystal simulation

Grain-scale in-situ study of discontinuous precipitation in Mg–Al

Revisiting the precipitation mechanisms of Guinier-Preston zones, η′, and η precipitates in Al-Zn-Mg alloys

Segregation assisted grain boundary precipitation in a model Al-Zn-Mg-Cu alloy

Correlative electron microscopy of discontinuous precipitation

Understanding the Anomalous Discontinuous Precipitation in Cu-Ni-X (X = Co,Fe) Alloys Based on CALPHAD Method and Phase-Field Simulation

Competition between continuous and discontinuous precipitation in L12-strengthened high-entropy alloys

Atomic-scale investigation of the heterogeneous precipitation in the E (Al18Mg3Cr2) dispersoid of 7075 aluminum alloy

The Formation Mechanism of a Novel Interfacial Phase with High Thermal Stability in a Mg-Gd-Y-Ag-Zr Alloy

Competition between continuous and discontinuous precipitation in L1(2)-strengthened high-entropy alloys

Precipitation Thermodynamics in an Al–Zn–Mg Alloy with Different Grain Sizes