Preparation and performance of nano silica/Nafion composite membrane for proton exchange membrane fuel cells

Keping Wang,Scott McDermid,Jing Li,Natalia Kremliakova,Paul Kozak,Chaojie Song,Yanghua Tang,Jianlu Zhang,Jiujun Zhang
DOI: https://doi.org/10.1016/j.jpowsour.2008.06.008
IF: 9.2
2008-01-01
Journal of Power Sources
Abstract:Composite membranes made from Nafion ionomer with nano phosphonic acid-functionalised silica and colloidal silica were prepared and evaluated for proton exchange membrane fuel cells (PEMFCs) operating at elevated temperature and low relative humidity (RH). The phosphonic acid-functionalised silica additive obtained from a sol–gel process was well incorporated into Nafion membrane. The particle size determined using transmission electron microscope (TEM) had a narrow distribution with an average value of approximately 11nm and a standard deviation of ±4nm. The phosphonic acid-functionalised silica additive enhanced proton conductivity and water retention by introducing both acidic groups and porous silica. The proton conductivity of the composite membrane with the acid-functionalised silica was 0.026Scm−1, 24% higher than that of the unmodified Nafion membrane at 85°C and 50% RH. Compared with the Nafion membrane, the phosphonic acid-functionalised silica (10% loading level) composite membrane exhibited 60mV higher fuel cell performance at 1Acm−2, 95°C and 35% RH, and 80mV higher at 0.8Acm−2, 120°C and 35% RH. The fuel cell performance of composite membrane made with 6% colloidal silica without acidic group was also higher than unmodified Nafion membrane, however, its performance was lower than the acid-functionalised silica additive composite membrane.
What problem does this paper attempt to address?