Abstract:Cryo-rolled aluminum alloys have a much higher strength-to-weight ratio than cold-rolled alloys, which makes them invaluable in the aerospace and automotive industries. However, this strength gain is frequently accompanied by a formability loss. When uniformly applied to the blank surface, hydroforming provides a solution by generating geometries with constant thickness, making it possible to produce complex structures with "near-net dimensions", which are difficult to achieve with conventional approaches. This study delves into the cavity die sheet hydroforming (CDSHF) process for high-strength cryo-rolled AA5083 aluminum alloy, focusing on two primary research questions. Firstly, we explored the utilization of a nonlinear 3D finite-element (FE) model to understand its impact on the dimensional accuracy of hydroformed components within the CDSHF process. Specifically, we investigated how decreasing fluid pressure and increasing the holding time of peak fluid pressure can be quantitatively assessed. Secondly, we delved into the optimization of process parameters—fluid pressure (FP), blank holding force (BHF), coefficient of friction (CoF), and flange radius (FR)—to achieve dimensional accuracy in hydroformed square cups through the CDSHF process. Our findings reveal that our efforts, such as reducing peak fluid pressure to 22 MPa, implementing a 30 s holding period, and utilizing an unloading path, enhanced component quality. We demonstrated this with a 35 mm deep square cup exhibiting a 16.1 mm corner radius and reduced material thinning to 5.5%. Leveraging a sophisticated nonlinear 3D FE model coupled with response surface methodology (RSM) and multi-objective optimization techniques, we systematically identified the optimal process configurations, accounting for parameter interactions. Our results underscore the quantitative efficacy of these optimization strategies, as the optimized RSM model closely aligns with finite-element (FE) simulation results, predicting a thinning percentage of 5.27 and a corner radius of 18.64 mm. Overall, our study provides valuable insights into enhancing dimensional accuracy and process optimization in CDSHF, with far-reaching implications for advancing metal-forming technologies.

Manufacture of an Automobile Lower Arm by Hydroforming

Analysis and design of hydroforming process for automobile lower arm by FEM

Preform design in hydroforming of automobile lower arm by FEM

Analysis and Design of Hydroforming Process for Automobile Rear Axle Housing by Fem

Research on the hydroforming law of variable cross-section shaped tubular automobile longitudinal arm

Analysis and Design of Hydroforming Processes by the Rigid–plastic Finite Element Method

FEM Analysis of Tube Preforming and Hydroforming Process for an Automotive Part

Analysis and experiment on tube hydroforming in a rectangular cross-sectional die

Rigid–plastic finite element analysis of hydroforming process and its applications

Reduction of Friction and Calibration Pressure by Section Preform During Hydroforming of Tubular Automotive Structural Components

Rigid-plastic finite element method and its implementation in the hydroforming processes

Finite element analysis of hydroforming process for sheet metal pairs

Hydroforming of Automotive Structural Components with Rectangular-Sections

Hydroforming of Typical Hollow Components

Numerical Simulation Research on Hydroforming Process of Automobile Front Transom

Pre-form Design for Hydro-Forming of Aluminum Alloy Automotive Cross Members

Hydroforming Processes and Equipments of Hollow Structures with Various Sections

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Analysis of Forming of Automotive Drawbar and Design of the Die

A 3D Non-Linear FE Model and Optimization of Cavity Die Sheet Hydroforming Process

DIE SHEET HYDROFORMING OF A COMPLEX-SHAPED AA2024-W AIRCRAFT SKIN PANEL — FROM CONCEPT TO FINAL COMPONENT